Snapper ESZT18336BVE important safety instructions Service Annually, Storage OUT of Season

Page 17

Section 3 - MAINTENANCE

WARNING

DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. Stop engine. Stop blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns, allow all parts to cool before working on machine. Fuel Filler Cap and Vent must be closed securely to prevent fuel spillage.

3.4SERVICE - ANNUALLY

Perform all maintenance as described in the maintenance schedule.

3.4.1. Engine

Service engine according to engine owner’s manual.

3.4.2. Air Filter

Refer to engine owner’s manual for service instructions.

3.4.3. Oil Filter

Refer to engine owner’s manual for service instructions.

3.4.4. Engine Oil

Refer to engine owner’s manual for service instructions.

3.4.5. Transaxle

IMPORTANT: DO NOT try to open reservoir cap at any time. The transaxle is maintenance free. The transaxle does not require any fluid or any service. If there is any problem: leakage, malfunction or etc. return the SCRAMBLER immediately to the nearest authorized Snapper dealer for service.

3.4.6. Fuel Filter

Service fuel filter as instructed below. Close fuel valve in fuel line. Run engine until engine runs out of fuel. Turn key to “OFF” position. Engine MUST be stopped and MUST be cold before removing filter. Perform filter change only when fuel line is empty.

1.Remove hose clamps from fuel filter.

2.Remove fuel lines from filter. Discard filter.

3.Install new fuel filter. Reinstall hose clamps. See Figure 3.10.

NEW FUEL FILTER

PART NO. 1-4359

HOSE CLAMPS

FIGURE 3.10

3.5 STORAGE (OUT OF SEASON)

Perform the following procedures to insure the SCRAMBLER will operate properly when taken out of storage.

1.Thoroughly clean the SCRAMBLER by removing all grass clippings and debris.

2.Perform maintenance and lubrication as described in the previous sections.

3.Drain fuel from fuel tank into an approved container outdoors away from all sources of ignition.

4.Start engine and allow it to run until engine runs out of fuel. This allows the carburetor and fuel system to remain clean during storage.

5.Remove battery. Refer to Section “BATTERY REMOVAL AND STORAGE”.

6.Close vent on fuel filler cap and fuel valve in fuel line. Remove key.

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Model Number Explanation ScramblerProtection Against Tipovers Protection for ChildrenPreparation From Previous ColumnOperation Safe Handling of GasolineTowing MaintenanceTable of Contents Nomenclature IntroductionEngine Speed & Choke Control Right Control Panel Cutting Deck Adjustment Handle Forward of Operator SeatParking Brake Next to Left Control Panel Applies park brake Motion Control LeversStopping Engine PRE-START Check ListEngine Operation 2.2.1. Starting Engine Getting Ready Motion ControlForward Motion Reverse MotionLeft turn shown right turn opposite Conventional TurningZERO-TURNING Stopping MotionMower Blade Engagement Mower Operation Cutting Height AdjustmentMowing Operations Mower Blade DisengagementEngine Must Begin to Stop if Engine Must not Start ifEngine should Start if Change Engine OIL Service After First 5 HoursCheck Mower Blade Single Blade DeckChecking Mower Belt Tension Service Every 25 Operating HoursEngine Engine Cooling System Engine Oil Oil Filter Air FilterMower Components Check EngineLubrication Underside View of 33 DeckFront Caster Wheel Pivot Shaft Front Wheel BearingsParking Brake Pivot Bushings Motion Control Pivot BushingsStorage OUT of Season Service AnnuallyTracking Adjustments Motion Control AdjustmentsNeutral Adjustments Mower Drive Belt Adjustment Engine Adjustments & RepairBelt Replacement DeckBelt Replacements Blade Brake AdjustmentFrom Previous Idler ARM and Belt Guide Detail+ 1/16 From Previous Page Checking the 33 Deck BladeDeck Shown Front or Rear View of DeckMower Deck Timing ROD Front to Rear Deck Pitch 38 DecksBlade Sharpening Wheel Brake AdjustmentMower Blade Replacement 4.5.1. Blade Wear Limits Mower Blade Replacement 4.5.3. Blade Replacement Blade Replacement ChartBattery Battery Removal Battery ServiceNEW Battery Preparation 1. Remove battery from carton Battery TestingCorrective Action Problem Probable CauseTrouble Shooting on Next Excessive Vibration Problem Probable Cause Corrective ActionMAINTENANCE/REPLACEMENT Parts Service Performed Each100 USE HRS SeasonDecal Identification European Noise Control Decal Disclaimer of Warranty Year Limited WarrantyPage Page Page Scrambler ZERO-TURN Hydro Drive European Model Series

ESZT18336BVE specifications

The Snapper ESZT18336BVE is a cutting-edge electric lawn mower designed for homeowners seeking efficiency, power, and ease of use. This innovative model integrates advanced technologies and features that enhance the mowing experience while ensuring a high-quality finish on various lawn types.

One of the standout features of the Snapper ESZT18336BVE is its powerful 36V lithium-ion battery system. This robust power source provides extended run time, allowing users to cover larger areas without the hassle of cords or frequent recharging. The battery is designed for quick charging, ensuring that the mower is ready when you are. Its energy-efficient operation not only reduces electricity costs but also contributes to a cleaner environment by emitting no harmful emissions.

The ESZT18336BVE boasts a versatile 18-inch cutting deck, ideal for small to medium-sized lawns. This size strikes a perfect balance between maneuverability and efficiency, enabling users to navigate around obstacles and corners with ease. The adjustable cutting height feature provides six different settings, ranging from 1 to 3.5 inches, allowing users to achieve their desired lawn height and adapt to varying grass types and seasonal growth.

Ergonomics play a significant role in the design of the Snapper ESZT18336BVE. The mower is equipped with a comfortable handle that can be adjusted to different heights, catering to users of varying statures while reducing strain during operation. The lightweight design further enhances ergonomics, making it easy to lift and transport.

Safety is paramount in the design of the Snapper ESZT18336BVE, featuring a reliable safety key that prevents accidental starting. Additionally, the mower integrates a blade brake system that stops the blade quickly when the user releases the control handles, providing peace of mind during operation.

The Snapper ESZT18336BVE also incorporates innovative mowing technologies, including a 3-in-1 mulching system that allows users to mulch, bag, or discharge grass clippings. This flexibility enables the efficient disposal of lawn waste and contributes to a healthier lawn by returning nutrients back into the soil.

In summary, the Snapper ESZT18336BVE combines power, convenience, and user-centric design. Its advanced battery technology, adjustable cutting deck, ergonomic features, and smart safety mechanisms make it an excellent choice for homeowners who prioritize performance and sustainability in their lawn care routine.
Top Page Image Contents