Snapper ESZT18336BVE Problem Probable Cause Corrective Action, Excessive Vibration

Page 28

TROUBLESHOOTING

PROBLEM

 

PROBABLE CAUSE

 

CORRECTIVE ACTION

 

 

 

Excessive Vibration

1. Damaged, out of balance or bent mower blades.

1. Service mower blade(s).

 

2. Loose blade components.

2. Service and tighten loose parts.

 

3. Loose or missing air lift (if equipped).

3. Replace air lifts. Tighten to proper torque.

 

4. Lumpy or frayed belt.

4. Replace belt.

 

5. Bent Idler, stationary or spindle pulley.

5. Replace pulley.

Rider Will Not Move Or

1. Motion Control Levers in neutral “N” position.

1.

Move levers in desired position.

Loss Of Traction

2. Roll release lever is in “ROLL” position.

2.

Move roll release lever to the engaged position.

 

3.

Low transmission hydraulic oil level.

3.

Contact authorized SNAPPER dealer.

 

4.

Parking Brake engaged.

4.

Move parking brake to disengaged position.

 

5.

Traction drive belt requires replacement.

5.

Replace traction drive belt.

Blade(s) Not Cutting

1. Blade engagement switch in the “OFF” position.

1.

Move blade switch to the “ON” position.

 

2.

Clutch belt slipping.

2.

Replace clutch belt.

 

3.

Mower belt slipping.

3.

Replace mower belt.

 

4.

Electric clutch not functioning.

4.

Contact authorized SNAPPER dealer.

Cutting Grass

1. Uneven tire pressure.

1.

Bring to proper pressure.

Improperly

2. Cutting height too low or high.

2.

Adjust cutting height.

 

3.

Engine speed too slow.

3.

Move engine speed control to “FAST” position.

 

4.

Forward speed too fast.

4.

Move joystick to a slower speed.

 

5.

Terraced cut, side to side.

5.

Adjust side to side level.

 

6.

Excessive deck pitch, front to rear.

6.

Adjust front to rear pitch.

 

7.

Cutting blade(s) dull or damaged.

7.

Sharpen cutting edges or replace blade(s).

 

8.

Blade belt slipping.

8.

Replace blade belt.

 

9.

Check electric clutch.

9.

Adjust to proper specifications.

 

10. Check clutch belt.

10. Replace clutch belt.

Poor Grass Discharge

1. Engine speed too slow.

1.

Move engine speed control to “FAST” position.

 

2.

Forward speed too fast.

2.

Move joystick to a slower speed.

 

3.

Grass is wet.

3.

Mow when grass is dry.

 

4.

Excessively worn or damaged blade(s).

4.

Service mower blade(s).

 

5.

Build up of grass clippings and debris under deck.

5.

Clean deck.

 

6.

Improper blade(s) installed on deck.

6.

Install proper SNAPPER blades.

 

7.

Blade(s) installed improperly on deck.

7.

Install blades properly.

Battery Will Not Charge

1. Poor cable connections.

1.

Clean cables and battery terminals.

 

2.

Bad battery cell(s).

2.

Replace with new battery.

 

3.

Faulty alternator.

3.

Contact engine manufacturer’s dealer.

Oil Leaking

1. Leaking hose fittings, clamps or reservoir.

1.

Verify fittings and hose clamps are tight.

28

24

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Scrambler Model Number ExplanationProtection for Children Protection Against TipoversPreparation From Previous ColumnSafe Handling of Gasoline OperationMaintenance TowingTable of Contents Introduction NomenclatureCutting Deck Adjustment Handle Forward of Operator Seat Engine Speed & Choke Control Right Control PanelParking Brake Next to Left Control Panel Applies park brake Motion Control LeversEngine Operation 2.2.1. Starting Engine PRE-START Check ListStopping Engine Motion Control Getting ReadyForward Motion Reverse MotionConventional Turning Left turn shown right turn oppositeZERO-TURNING Stopping MotionMower Operation Cutting Height Adjustment Mower Blade EngagementMowing Operations Mower Blade DisengagementEngine should Start if Engine Must not Start ifEngine Must Begin to Stop if Service After First 5 Hours Change Engine OILCheck Mower Blade Single Blade DeckService Every 25 Operating Hours Checking Mower Belt TensionEngine Engine Cooling System Engine Oil Oil Filter Air FilterCheck Engine Mower ComponentsLubrication Underside View of 33 DeckFront Wheel Bearings Front Caster Wheel Pivot ShaftParking Brake Pivot Bushings Motion Control Pivot BushingsService Annually Storage OUT of SeasonNeutral Adjustments Motion Control AdjustmentsTracking Adjustments Engine Adjustments & Repair Mower Drive Belt AdjustmentBelt Replacement DeckBlade Brake Adjustment Belt ReplacementsFrom Previous Idler ARM and Belt Guide DetailFrom Previous Page Checking the 33 Deck Blade + 1/16Front or Rear View of Deck Deck ShownFront to Rear Deck Pitch 38 Decks Mower Deck Timing RODMower Blade Replacement 4.5.1. Blade Wear Limits Wheel Brake AdjustmentBlade Sharpening Blade Replacement Chart Mower Blade Replacement 4.5.3. Blade ReplacementBattery Battery Removal Battery ServiceBattery Testing NEW Battery Preparation 1. Remove battery from cartonTrouble Shooting on Next Problem Probable CauseCorrective Action Problem Probable Cause Corrective Action Excessive VibrationService Performed Each MAINTENANCE/REPLACEMENT Parts100 USE HRS SeasonDecal Identification European Noise Control Decal Year Limited Warranty Disclaimer of WarrantyPage Page Page Scrambler ZERO-TURN Hydro Drive European Model Series

ESZT18336BVE specifications

The Snapper ESZT18336BVE is a cutting-edge electric lawn mower designed for homeowners seeking efficiency, power, and ease of use. This innovative model integrates advanced technologies and features that enhance the mowing experience while ensuring a high-quality finish on various lawn types.

One of the standout features of the Snapper ESZT18336BVE is its powerful 36V lithium-ion battery system. This robust power source provides extended run time, allowing users to cover larger areas without the hassle of cords or frequent recharging. The battery is designed for quick charging, ensuring that the mower is ready when you are. Its energy-efficient operation not only reduces electricity costs but also contributes to a cleaner environment by emitting no harmful emissions.

The ESZT18336BVE boasts a versatile 18-inch cutting deck, ideal for small to medium-sized lawns. This size strikes a perfect balance between maneuverability and efficiency, enabling users to navigate around obstacles and corners with ease. The adjustable cutting height feature provides six different settings, ranging from 1 to 3.5 inches, allowing users to achieve their desired lawn height and adapt to varying grass types and seasonal growth.

Ergonomics play a significant role in the design of the Snapper ESZT18336BVE. The mower is equipped with a comfortable handle that can be adjusted to different heights, catering to users of varying statures while reducing strain during operation. The lightweight design further enhances ergonomics, making it easy to lift and transport.

Safety is paramount in the design of the Snapper ESZT18336BVE, featuring a reliable safety key that prevents accidental starting. Additionally, the mower integrates a blade brake system that stops the blade quickly when the user releases the control handles, providing peace of mind during operation.

The Snapper ESZT18336BVE also incorporates innovative mowing technologies, including a 3-in-1 mulching system that allows users to mulch, bag, or discharge grass clippings. This flexibility enables the efficient disposal of lawn waste and contributes to a healthier lawn by returning nutrients back into the soil.

In summary, the Snapper ESZT18336BVE combines power, convenience, and user-centric design. Its advanced battery technology, adjustable cutting deck, ergonomic features, and smart safety mechanisms make it an excellent choice for homeowners who prioritize performance and sustainability in their lawn care routine.
Top Page Image Contents