Snapper ESZT18336BVE Blade Replacement Chart, Mower Blade Replacement 4.5.3. Blade Replacement

Page 25

Section 4 - ADJUSTMENTS & REPAIR

WARNING

DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. Stop engine. Stop blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns, allow all parts to cool before working on machine. Fuel Filler Cap and Vent must be closed securely to prevent fuel spillage. DO NOT attempt to service or charge the battery while it is installed on the SCRAMBLER. Shield the positive terminal with terminal cover located on battery harness. This prevents metal from touching the positive terminal, which could cause sparks. Cables must be connected to battery terminals in the proper position as shown.

4.5MOWER BLADE REPLACEMENT 4.5.3. BLADE REPLACEMENT

1.Remove blade(s). See Figure 4.17. Replace blade(s) if it shows signs of excessive wear or damage. See chart below for replacement

BLADE REPLACEMENT CHART

33”

Blade

1-9523

38”

Blades

2-4466 (Requires Two)

4.6BATTERY

4.6.1. BATTERY REMOVAL

1.Tilt seat up to gain access to battery.

2.Observe and note cable positions on battery. See Figure 4.18.

3.Disconnect cables from battery terminals, disconnecting BLACK (Negative) cable first. Disconnect RED (Positive) battery cable. Slide battery from battery cradle.

4.Retain mounting bolts and nuts for future use.

4.6.2.BATTERY INSTALLATION 1. Slide battery into battery cradle.

2. Connect cables to battery terminals. Connect RED (Positive) cable first. Connect BLACK (Negative) cable. See Figure 4.18.

3. Place the positive (+) terminal insulator over positive terminal and cable. See Figure 4.18.

4.6.3.BATTERY SERVICE

1.Remove battery. Refer to Section “BATTERY REMOVAL”.

2.Place battery in a well-ventilated area on a level surface.

3.Using distilled water, refill cells as required to cover cell plates of which can also be visualized through the plastic battery case.

4.With cell caps removed, connect battery charger to battery terminals. Red to positive (+) terminal and black to negative (-) terminal.

5.Slow charge battery at 1 amp for 10 hours.

6.If battery will not accept charge or is partially charged after 10 hours of charging at 1 amp, replace with new battery, Part Number 6-0753.

BLACK

NEGATIVE (-)

CABLE

RED

POSITIVE (+)

CABLE

FIGURE 4.18

WARNING

The electrolyte (acid) produces a highly explosive gas. Keep all sparks, flame and fire away from area when charging battery or when handling electrolyte or battery. Electrolyte (acid) is a highly corrosive liquid. Wear eye protection. Wash affected areas immediately after having eye or skin contact with electrolyte (acid). Battery acid is corrosive. Rinse empty acid containers with water and mutilate before discarding. If acid is spilled on battery, bench, or clothing, etc., Flush with clear water and neutralize with baking soda. DO NOT attempt to charge battery while installed on the SCRAMBLER. DO NOT use “BOOST” chargers on the battery. If battery is removed, DO NOT operate engine without insulating Positive + battery cable terminal with electrical tape, or sparking from the battery cables can result.

4.6.4. BATTERY STORAGE

If SCRAMBLER is to be stored out of season on its rear bumper, it is recommended the battery be removed, charged and stored.

1.Remove battery. (Refer to Section “BATTERY REMOVAL”).

2.Perform battery service.

3.Bring battery to full charge, if required.

4.Store battery in an area away from the SCRAMBLER on a wood surface. DO NOT STORE BATTERY ON A CONCRETE SURFACE.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Model Number Explanation ScramblerProtection Against Tipovers Protection for ChildrenPreparation From Previous ColumnOperation Safe Handling of GasolineTowing MaintenanceTable of Contents Nomenclature IntroductionEngine Speed & Choke Control Right Control Panel Cutting Deck Adjustment Handle Forward of Operator SeatParking Brake Next to Left Control Panel Applies park brake Motion Control LeversEngine Operation 2.2.1. Starting Engine PRE-START Check ListStopping Engine Getting Ready Motion ControlForward Motion Reverse MotionLeft turn shown right turn opposite Conventional TurningZERO-TURNING Stopping MotionMower Blade Engagement Mower Operation Cutting Height AdjustmentMowing Operations Mower Blade DisengagementEngine should Start if Engine Must not Start ifEngine Must Begin to Stop if Change Engine OIL Service After First 5 HoursCheck Mower Blade Single Blade DeckChecking Mower Belt Tension Service Every 25 Operating HoursEngine Engine Cooling System Engine Oil Oil Filter Air FilterMower Components Check EngineLubrication Underside View of 33 DeckFront Caster Wheel Pivot Shaft Front Wheel BearingsParking Brake Pivot Bushings Motion Control Pivot BushingsStorage OUT of Season Service AnnuallyNeutral Adjustments Motion Control AdjustmentsTracking Adjustments Mower Drive Belt Adjustment Engine Adjustments & RepairBelt Replacement DeckBelt Replacements Blade Brake AdjustmentFrom Previous Idler ARM and Belt Guide Detail+ 1/16 From Previous Page Checking the 33 Deck BladeDeck Shown Front or Rear View of DeckMower Deck Timing ROD Front to Rear Deck Pitch 38 DecksMower Blade Replacement 4.5.1. Blade Wear Limits Wheel Brake AdjustmentBlade Sharpening Mower Blade Replacement 4.5.3. Blade Replacement Blade Replacement ChartBattery Battery Removal Battery ServiceNEW Battery Preparation 1. Remove battery from carton Battery TestingTrouble Shooting on Next Problem Probable CauseCorrective Action Excessive Vibration Problem Probable Cause Corrective ActionMAINTENANCE/REPLACEMENT Parts Service Performed Each100 USE HRS SeasonDecal Identification European Noise Control Decal Disclaimer of Warranty Year Limited WarrantyPage Page Page Scrambler ZERO-TURN Hydro Drive European Model Series

ESZT18336BVE specifications

The Snapper ESZT18336BVE is a cutting-edge electric lawn mower designed for homeowners seeking efficiency, power, and ease of use. This innovative model integrates advanced technologies and features that enhance the mowing experience while ensuring a high-quality finish on various lawn types.

One of the standout features of the Snapper ESZT18336BVE is its powerful 36V lithium-ion battery system. This robust power source provides extended run time, allowing users to cover larger areas without the hassle of cords or frequent recharging. The battery is designed for quick charging, ensuring that the mower is ready when you are. Its energy-efficient operation not only reduces electricity costs but also contributes to a cleaner environment by emitting no harmful emissions.

The ESZT18336BVE boasts a versatile 18-inch cutting deck, ideal for small to medium-sized lawns. This size strikes a perfect balance between maneuverability and efficiency, enabling users to navigate around obstacles and corners with ease. The adjustable cutting height feature provides six different settings, ranging from 1 to 3.5 inches, allowing users to achieve their desired lawn height and adapt to varying grass types and seasonal growth.

Ergonomics play a significant role in the design of the Snapper ESZT18336BVE. The mower is equipped with a comfortable handle that can be adjusted to different heights, catering to users of varying statures while reducing strain during operation. The lightweight design further enhances ergonomics, making it easy to lift and transport.

Safety is paramount in the design of the Snapper ESZT18336BVE, featuring a reliable safety key that prevents accidental starting. Additionally, the mower integrates a blade brake system that stops the blade quickly when the user releases the control handles, providing peace of mind during operation.

The Snapper ESZT18336BVE also incorporates innovative mowing technologies, including a 3-in-1 mulching system that allows users to mulch, bag, or discharge grass clippings. This flexibility enables the efficient disposal of lawn waste and contributes to a healthier lawn by returning nutrients back into the soil.

In summary, the Snapper ESZT18336BVE combines power, convenience, and user-centric design. Its advanced battery technology, adjustable cutting deck, ergonomic features, and smart safety mechanisms make it an excellent choice for homeowners who prioritize performance and sustainability in their lawn care routine.
Top Page Image Contents