Snapper CP215019KW, CP215519HV From Previous, Do not refuel the machine indoors

Page 3

IMPORTANT SAFETY INSTRUCTIONS

SAFE HANDLING OF GASOLINE

(Continued From Previous Page)

3.DO NOT remove fuel cap or add fuel with the engine running. Allow the engine to cool before refueling.

4.DO NOT refuel the machine indoors.

5.DO NOT store the machine or fuel container inside where there is an open flame, spark or pilot light such as on a water heater or other appliances.

6.DO NOT fill fuel containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place the containers on the ground away from the vehicle before filling.

7.Remove gas-powered equipment from the vehicle or trailer and refuel it on the ground. If this is not possible, then refuel equipment using a portable container, rather than a gasoline dispenser nozzle.

8.DO NOT start gas powered equipment in enclosed vehicles or trailers.

9.Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete. DO NOT use a nozzle lock-open device

10.If fuel is spilled on clothing, change clothing immediately.

11.DO NOT overfill a fuel tank. Replace fuel cap and tighten securely.

OPERATION

1.DO NOT put hands or feet near or under rotating parts. Keep clear of discharge area while engine is running.

2.STOP engine when crossing gravel drives, walks, or roads, and under any conditions where thrown objects might be a hazard.

3.Mow only in daylight or good artificial light.

4.DO NOT operate mower while under the influence of alcohol or drugs.

5.After striking a foreign object or if mower vibrates abnormally, STOP the engine, disconnect and secure spark plug wire. Inspect the mower for any damage and repair the damage before starting.

6.DO NOT mow near drop offs, ditches or embankments. Operator could lose footing or balance.

7.STAY ALERT for holes and other hidden hazards. Tall grass can hide obstacles. Keep away from ditches, washouts, culverts, fences and protruding objects.

8.DO NOT mow on wet grass. Always be sure of your footing. Keep a firm hold on the handle and walk, never run. Slipping could cause injury.

9.ALWAYS stay behind handle when engine (motor) is running.

10.DO NOT leave the machine with the engine running. STOP BLADE and STOP ENGINE before leaving the operators position for any reason.

3

OPERATION

(Continued From Previous Column)

11.Before cleaning, repairing or inspecting make certain engine, blade and all moving parts have STOPPED. Disconnect and secure spark plug wire away from plug to prevent accidental starting.

12.STOP engine and wait until the blade comes to complete STOP before removing grass bag and/or clearing grass.

13.DO NOT operate mower without the entire grass catcher, discharge guard, rear guard or other safety devices in place and working. DO NOT point discharge at people, passing cars, windows or doors.

14.DO NOT discharge material against a wall or obstruction. Materialmayricochetbacktowardstheoperator.

15.Slow down before turning.

16.Watch out for traffic when near or crossing roadways.

17.DO NOT operate engine in enclosed areas. Engine exhaust gases contain carbon monoxide, a deadly poison.

18.Only use accessories approved by the manufacturer. See manufacturer’s instructions for proper operation and installationofaccessories.

MAINTENANCE AND STORAGE

1.DO NOT store mower or fuel container inside where fumes may reach an open flame, spark or pilot light such as in a water heater, furnace, clothes dryer or other gas appliance. Allow engine to cool before storing machine in an enclosure. Store fuel container out of reach of children in a well ventilated, unoccupied building.

2.Keep mower and engine free of grass, leaves or excess grease to reduce fire hazard and engine overheating.

3.When draining fuel tank, drain fuel into an approved container outdoors and away from open flame.

4.Keep all bolts, especially blade bolts, nuts and screws properly tight. Check that all cotter pins are in proper position.

5.Always provide adequate ventilation when running engine. Engine exhaust gases contain carbon monoxide, a deadly poison.

6.Service engine and make adjustments only when engine is stopped. Removed spark plug wire from spark plug and secure wire away from spark plug to prevent accidental starting.

7.DO NOT change engine governor speed settings or overspeed engine.

8.Check grass bag assembly frequently for wear or deterioration to avoid thrown objects and exposure to moving parts. Replace with new bag if loose seams or tears are evident. Replace slider or bag adapter if broken or cracked.

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Steel Deck Walk Mowers Commercial Models Series Engine Designation Series Designation Engine Horse PowerImportant Safety Instructions From Previous Do not refuel the machine indoorsFrom Previous Column Important Safety Instructions Table of Contents Engine Speed Control IntroductionNomenclature Starting & Operation Engine & Blade PRE-START Check ListStopping Handle Height AdjustmentCutting Height Adjustment Propelling MowerLatch Position Cutting Height Settings Removing and Dumping Grass Catcher Slide Closure Type Recycling Operation Dispose of drain oil properly Service After First 5 Hours 3.2.1. Change Engine OILCheck Engine Drive Belt Service AnnuallyStorage Procedure Check Mower BladeMower Blade Replacement Standard Blade Wear Limit Blade Sharpening1.A. Ninja Blade Wear Limit Wheel Drive Control Adjustment Driven Disc Adjustment Driven and Drive Disc ServiceCleaning Drive Disc & Driven Disc Drive Spring Repair/ReplacementOn Next Replacing Driven Disc Rubber Ring Reassemble components in reverse order Remove bearing and replace with new bearingBelt Service Engine Drive Belt Replacement Stretch Type BeltsOn Next Pulley Position Reinstall blade hub and cutter bladeCorrective Action Problem Probable CauseUSE HRS Season Service Performed EachMAINTENANCE/REPLACEMENT Parts 100Disclaimer of Warranty Year Limited WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Snapper Product Registration Form Page Page Page Steel Deck Walk Behind Mowers Commercial Models Series

CP215019KW, CP215519HV, CP216019KWV, CP215519HV specifications

The Snapper CP216019KWV, CP215519HV, CP215019KW, and CP215519HV models are robust lawn mowers designed to cater to various residential and professional mowing needs. Each model is built with cutting-edge technologies and features that enhance performance, durability, and user-friendliness.

The CP216019KWV is favored for its powerful 21-inch cutting deck that allows for efficient mowing over large areas. With a 190cc engine, it delivers reliable performance and impressive torque, ensuring that grass cutting is smooth and effortless. The adjustable cutting height provides users with the flexibility to achieve their desired lawn appearance, making it suitable for different grass types. Furthermore, it boasts a self-propelling mechanism which allows for easy maneuvering, especially on hilly terrains.

In contrast, the CP215519HV model stands out with its innovative Variable Speed Drive system. This feature enables the operator to adjust the mower's speed according to their walking pace, making it more comfortable to use over extended periods. The 21-inch deck is also designed for versatility, allowing for both bagging and mulching options, which enhances the mowing experience and benefits lawn health.

The CP215019KW is another model that focuses on efficiency and power. With a 150cc engine, this mower is lightweight yet formidable, providing enough power for residential yard maintenance. Its compact design makes it easy to store, while still offering features like an easy-start recoil and a durable steel deck that guarantees longevity. The integrated bagging system collects clippings neatly, keeping lawns tidy.

Finally, the CP215519HV model presents a balanced option with user-friendly features and a solid construction. It integrates a powerful engine that ensures consistent grass cutting capabilities and a quick-change height adjustment lever to transition seamlessly between different grass lengths. Its dual-lever height adjustment system enhances precision, allowing for custom cutting heights tailored to specific lawn requirements.

All four models are equipped with Snapper's commitment to quality, making them excellent choices for anyone looking to maintain a manicured lawn. With ergonomic designs, easy-to-use features, and durable construction, they provide powerful solutions for both novice and seasoned gardeners alike.
Top Page Image Contents