Snapper 7800841-01, 780084-01 manual Propelling the Mower, Starting the Mower, Fuel Recommendations

Page 12

Operation

Fuel Recommendations

 

The engine on your mower is equipped with the Briggs

Fuel must meet these requirements:

 

& Stratton Ready StartTM System. This features a

 

• Clean, fresh, unleaded gasoline.

 

temperature-controlled automatic choke. No additional

 

• A minimum of 87 octane/87 AKI (91 RON). High

steps are required to start a cold engine.

 

altitude use, see below.

 

1. Move the engine speed control (A, Figure 3) to

 

• Gasoline with up to 10% ethanol (gasahol) is

 

 

the fast (‘Rabbit’) position.

 

acceptable.

 

2. Squeeze the blade control (B) against the handle.

NOTICE: Do not use unapproved gasolines, such as

3. Start the mower: Pull the rope start handle (C)

 

to crank the engine.

E15 and E85. Do not mix oil in gasoline or modify the

4. To stop the engine (and blade), release the blade

engine to run on alternate fuels. Use of unapproved

 

control.

fuels will damage the engine components and void

5. After the engine starts, allow a brief warm-up until

the engine warranty.

 

 

the engine runs smooth before beginning mower

To protect the fuel system from gum formation, mix a

 

operation.

fuel stabilizer into the fuel. See Storage. All fuel is not

 

 

 

B

the same. If starting or performance problems occur,

 

change fuel providers or change brands. This engine is

 

 

certified to operate on gasoline. The emissions control

 

 

system for this engine is EM (Engine Modifications).

 

 

High Altitude

 

 

A

At altitudes over 5,000 feet (1524 meters), a minimum

 

 

85 octane/85 AKI (89 RON) gasoline is acceptable.

 

C

To remain emissions compliant, high altitude adjust-

 

ment is required. Operation without this adjus ment will

 

 

cause decreased performance, increased fuel

n-

 

 

sumption, and increased emissions. See an auth

rized

 

 

Briggs & Stratton Dealer for high altitude adjustment

 

 

information.

 

 

Figure 3: Starting the mower

Operation of the engine at altitudes below 2,500 feet

 

 

 

(762 meters) with the high altitude adjustment is not

Propelling the Mower

recommended.

 

 

 

 

 

1. Start the mower.

Starting the Mower

 

2. Move the ground speed control (A, Figure 4) to

 

 

the desired speed position.

 

 

WARNING

 

3. Squeeze the wheel drive control (B) against the

 

 

 

 

handle to engage the wheel drive and propel the

 

 

POISONOUS GAS HAZARD. Engine exhaust contains carbon

 

mower forward. Forward speed can be adjusted

 

 

 

 

monoxide, a poisonous gas that could kill you in minutes. You

 

while the mower is moving by changing the posi-

 

 

if you do not smell

 

 

 

 

 

 

 

CANNOT see it, smell it, or taste it. EvenReproduction

 

 

exhaust fumes, you could still be exposed to carbon monox-

 

tion of the ground speed control.

 

 

ide gas. If you start to feel sick, dizzy, or weak while using this

 

 

 

 

product, shut it off and get to fresh air RIGHT AWAY. See a

 

 

 

 

 

 

 

 

doctor. You may have carbon monoxide poisoning.

 

 

A

 

• Operate this product ONLY outside far away from windows, doors and

 

 

vents to reduce the risk of carbon monoxide gas from accumulating and

 

 

 

potentially being drawn towards occupied spaces.

 

 

 

 

• Install battery-operated carbon monoxide alarms or plug-in carbon

 

B

 

monoxide alarms with battery back-up according to the manufacturer’s

 

 

instructions. Smoke alarms cannot detect carbon monoxide gas.

 

 

 

DO NOT run this product inside homes, garages, basements, crawlspac- es, sheds, or other partially-enclosed spaces even if using fans or open- ing doors and windows for ventilation. Carbon monoxide can quickly build up in these spaces and can linger for hours, even after this product has shut off.

ALWAYS place this product downwind and point the engine exhaust away from occupied spaces.

Figure 4: Mower drive controls

12

www.snapper.com

Image 12
Contents Reproduction Not ErenceTable of Contents Operator Safety Operating SafetyMoving Parts Ol. Clean sp lled fuel a d oil from machine. do not This manual and on the mower, engine and attachMents. Know the controls and the proper use Mower before startingDisconnect and secure spark plug wire away from plug Use only an approved fuel containerThan a gasoline dispenser nozzle Container outdoors and away from open flameOperator Safety Safety and Operation Decals Lowed. Not following these important warningsInstructions can result in serious bodily injury or DeathExplanation of Safety Decals Explanation of Operation DecalsFeatures and Controls For Not Reprodu ctionBefore Starting Operation Oil RecommendationsPropelling the Mower Starting the MowerFuel Recommendations Stopping the Mower Cutting Height Adjustment Handle Height AdjustmentMulching Operation Installing the Discharge DeflectorRemoving the Mulching Cover Installing the mulching plug Operation Installing the Grass Bag NotMaintenance Maintenance Chart Emissions ControlChange Engine Oil Service Air Filter Not overfillCheck Safety Interlock System Clean Debris Off MowerStorage Procedure Fuel SystemMaintenance Service Check Mower BladeCheck Grease Level in Transmission ReproductionCheck Engine Drive BeltMaintenance Mower Blade Replacement Blade SharpeningMaintenance AdjustmentWheel Drive Control Blade SharpeningMaintenance Driven and Drive Disc Service Drive Spring Repair/ReplacementDriven Disc Adjustment Cleaning Drive Disc & Driven DiscDriven Disc Replacement Proper driven disc adjustmentDriven Disc Replacement Driven Disc Bearing Replacement Removing the driven disc assemblyBelt Service Engine Drive Belt Replacement StretchReplacing the Bearing On the Pulley End Hex ShaftEngine Drive Belt Replacement Stretch Type Belts Ansmiss Ly-V Belt ReplacementTroubleshooting Clean free of all debrisFuel tank empty Fill fuel tank with fresh fuel Blade control is released or is not being heldLimited Warranty WarrantiesBriggs & Stratton Emissions Control Warranty Provisions Slope Guide Power Rating MowerEngine Manuel dutilisation Machine Fontionnement Guide de conduite sur lesSécurité de lopérateur Pièces en mouvement Objets projetésAccumulation de débris Carburant et entretienPréparation Manipulation D’ESSENCE EN Toute Sécurité de lopérateur Étiquettes de sécurité et de FonctionnementReproduction Explication des étiquettes aut Llantes d’utilisationFonctions et commandes Commande de régime moteur Commande d’entraînementAvez des questions Poignée à corde du démarreurAvant le démarrage Fontionnement Déplacement de la tondeuse Recommandations de carburantDémarrer la tondeuse Fontionnement Arrêter la tondeuse Réglage de la hauteur de CoupeOpération de déchiquetage Installation du déflecteur ’éjectionDépose du couvercle de DéchiquetagePose de la fiche de déchiquetage Fontionnement Installation du sac à herbe AvertissementEntretien Tableau de maintenance Contrôle démissionEntretien Changer lhuile moteur Entretien du filtre à air Pient approprié. Éliminer l’huile usagée de façon approDu dépoussiéreur sur la partie inférieure des élé Entretien Vérifier le système deVerrouillage de sécurité Débarrassez la tondeuse deVérifiez la lame de la tondeuse Vérification du niveau de graisse de laTransmission Vérifiez la courroie d’entraînement duEntretien Remplacement de lame de tondeuse Limite dusure de lame standard Aiguisage de lameLimite dusure de lame NinjaReproduction Moteur saturera le filtre à air et rendra le démarrage duAiguisage de lame suite LameRéparation ou remplacement du ressort dentraînement ReproductionRéglage Courroie en V D ou courroie dentraînement du moteur UséeReprod uction Entraîné Remplacement du roulement à lextrémité Remplacement de la courroie dentraîneEntretien de la courroie De poulie de larbre hexagonalRemplacement de la courroie en V de Transmiss nDépannage ProblèmeGaranties Garantie LimitéeSeptembre Sur les pentes Guide de conduiteSpécifications 7800841-01 7800842-01 TondeuseMoteur

7800841-01, 780084-01, 7800842-01 specifications

The Snapper 7800842-01, 780084-01, and 7800841-01 are cutting-edge lawn care equipment designed to enhance the mowing experience while providing outstanding performance and reliability for homeowners and professionals alike. These models are part of Snapper's extensive lineup of outdoor power equipment, recognized for their durability and innovative features.

One of the main features of the Snapper 7800842-01 series is its advanced cutting technology. It is equipped with a robust 21-inch steel mowing deck, which ensures a clean and efficient cut, allowing users to tackle various lawn types and conditions. The durable construction of the deck not only enhances its longevity but also offers superior performance in mulching, bagging, or side-discharging grass clippings.

The Snapper series employs a powerful engine that delivers robust performance. With a reliable Briggs & Stratton engine, users can expect easy starting and impressive fuel efficiency. This engine is designed to provide ample torque for tackling tough grassy areas while ensuring smooth operation, reducing the effort required for maintaining your lawn.

Another notable feature is the adjustable cutting height system, which allows for easy customization of grass height. Users can quickly set their desired height for optimal mowing results, accommodating different grass types and seasonal growth patterns. This versatility is essential for achieving the perfect lawn manicuring experience.

Comfort is a priority in the design of the Snapper 7800842-01 series. The ergonomic handle design reduces operator fatigue, making it easier to maneuver the mower over more extensive areas. Additionally, the foldable handle feature simplifies storage and transportation, catering to users with limited space.

Safety features are also integrated into these models, ensuring peace of mind for users. An operator presence control system immediately stops the blade when the user releases the handle, preventing accidents.

Overall, the Snapper 7800842-01, 780084-01, and 7800841-01 models are a testimony to Snapper's commitment to quality and innovation. With their combination of reliable power, efficient cutting capabilities, and user-friendly design, they are well-suited for maintaining a pristine lawn. Whether used by homeowners seeking a perfect yard or professionals needing dependable equipment, these mowers stand out as excellent choices in the realm of outdoor power tools.