Snapper 7800392, 7800382 Installing the Seat Safety Switch, Installing the seat safety switch

Page 10

Axion / 150Z Series

Installing the Seat

Safety Switch

1.Squeeze the side clips of the safety switch (A, Figure 6), and insert the switch into the slot (B) in the seat bottom. Be sure to slide the switch fully forward.

2.Connect the harness terminal housing (C) to the seat switch.

3.Loop the wire tie (D) around both the switch body and the terminal housing.

Figure 6. Installing the seat safety switch

TP 300-5412---ZT-SN

8/2008

Image 10

Contents Axion / 150Z Series Table of Contents Safety Rules Ignition System Service and Maintenance Quick Setup List Uncrating Important NoteBattery Activation Installation Charge BatteryInstalling the Seat Installing the seatInstalling the Seat Safety Switch Installing the seat safety switchSetting Up the Ground Speed Control Levers Setting up the ground speed leversTorque Mower Blade Hardware Torquing the mower blade hardware 33 DeckTorquing the mower blade hardware 50 Deck Check Fluid Levels Reduce & Check Tire PressuresLubrication GreaseCheck Rider Safety System Burnish PTO Clutch