Snapper 7800375, 7800392, 7800382, 7800393, 7800386, 7800374, 7800381 manual Uncrating, Important Note

Page 7

Axion / 150Z Series

Uncrating

1.Using a reciprocating utility saw or equivalent, cut crate away from bottom skid. Remove crate. Remove plastic wrap.

2.Cut any banding securing the unit.

IMPORTANT NOTE

When cutting crate from bottom skid, use caution around tires and mower rollers.

3.Locate the transmission release levers (C, Figure 1) at the rear of the unit.

4.Pull both levers back and down to release the trans- missions (position B, Figure 1).

5.Pull the ground speed control levers in to their DRIVE positions, and disengage the parking brake.

The rider can now be pushed by hand.

6.After moving the rider, set the ground speed control levers to START/PARK, engage the parking brake, and push both transmission release levers forward to re-engage the transmissions (position A, Figure 1).

DO NOT TOW RIDER

Towing the unit will cause transmission dam- age. Do not use another vehicle to push or pull this unit. Do not use this unit to push or pull another vehicle or object.

A

B

C

Figure 1. Pushing the rider

8/2008

7

TP 300-5412---ZT-SN

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Axion / 150Z Series Table of Contents Safety Rules Ignition System Service and Maintenance Quick Setup List Important Note UncratingCharge Battery Battery Activation InstallationInstalling the seat Installing the SeatInstalling the seat safety switch Installing the Seat Safety SwitchSetting up the ground speed levers Setting Up the Ground Speed Control LeversTorquing the mower blade hardware 33 Deck Torque Mower Blade HardwareTorquing the mower blade hardware 50 Deck Reduce & Check Tire Pressures Check Fluid LevelsGrease LubricationBurnish PTO Clutch Check Rider Safety System
Top Page Image Contents