Snapper 7800382 Setting Up the Ground Speed Control Levers, Setting up the ground speed levers

Page 11

Axion / 150Z Series

Setting Up the Ground Speed Control Levers

1.Loosen (do not remove) the hardware securing the ground speed control levers to the lever bases.

2.Raise the levers, aligning the upper hole in each lever with the upper slotted hole in the lever base.

3.Install the noted hardware as shown in Figure 7. Tighten all hardware. Torque to 15-17 ft. lbs. (20-23 N.m.).

Note: Ground speed control levers must be adjusted prior to use. Refer to the Section ‘Ground Speed Control Lever Adjustment’ in the Operator’s Manual.

C

A

B

20-23 N.m.

15-17 ft. lbs.

A

B

C

5/16-18

5/16-18 x 1-3/4

Figure 7. Setting up the ground speed levers

8/2008

11

TP 300-5412---ZT-SN

Image 11
Contents Axion / 150Z Series Table of Contents Safety Rules Ignition System Service and Maintenance Quick Setup List Important Note UncratingCharge Battery Battery Activation InstallationInstalling the seat Installing the SeatInstalling the seat safety switch Installing the Seat Safety SwitchSetting up the ground speed levers Setting Up the Ground Speed Control LeversTorquing the mower blade hardware 33 Deck Torque Mower Blade HardwareTorquing the mower blade hardware 50 Deck Reduce & Check Tire Pressures Check Fluid LevelsGrease LubricationBurnish PTO Clutch Check Rider Safety System