Snapper 3317523BVE Check the Blade Drive Belt, Blade Brake, Service Brake / Park Brake

Page 16

Maintenance (Continued)

!

WARNING

!

DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. STOP engine. STOP blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns, allow all parts to cool before working on machine. Fuel Filler Cap and vent must be closed securely to prevent fuel spillage.

Service - After the First 5 Hours (Continued)

Check the Blade Drive Belt

The blade drive consists of a single belt from the engine to the deck. Inspect for signs of deterioration and proper ten- sion.

1.Lower the deck to the lowest setting.

2.Remove the four self-tapping screws (A, Figure 21), two on each side of mower drive belt cover (B).

3.Slide the cover back and rotate out on the left side of the mower deck.

A

Maintenance

B

 

 

Figure 21: Removing the drive belt cover

4.Raise the deck to the 3rd height of cut position (middle notch). With the engine “OFF”, move the blade lever back to the “ON” position and depress the blade pedals.

5.28” and 30” Decks *: Measure the belt spacing at the idler pulley (A, Figure 22). The belt spacing (B) should be 1-1/4” but no less than 1”. If the measurement is less than 1”, the belt tension should be adjusted. Refer to the section entitled “BLADE DRIVE BELT ADJUST- MENT”.

*IMPORTANT: The blade drive belt on 33” decks does not require tension adjustment. If the belt becomes worn or slack it must be replaced. Refer to the section entitled

“BLADE DRIVE BELT REPLACEMENT”.

B

A

Figure 22: Measuring the belt spacing

!

WARNING

!

The following procedure requires the engine and blades to be operated. Exercise extreme caution. Clear area of loose parts & tools first. Only operate blades when seated in the operator’s seat.

Blade Brake

1.Check the blade brake for proper function. The blade should stop rotating in 3 seconds or less after moving the blade control lever to the “OFF” position or after releasing the blade pedals.

!

WARNING

!

Blades must stop rotating in 3 seconds or less after the blade has been turned off. DO NOT operate machine until blade brake has been adjusted and functioning properly.

2.If the blade continues to rotate longer than 3 seconds do not operate the machine. Refer to the section entitled “BLADE BRAKE ADJUSTMENT”, or contact your SNAPPER dealer for assistance.

Service Brake / Park Brake

1. Check the machine brake for proper function:

Engage the park brake, and push the machine. The rear tires should skid.

Drive the machine forward and apply the brake. The machine should come to a complete stop in less than 5 ft.

2.If the brakes are not functioning properly, brake adjust- ment must be completed before operating the machine. Refer to the section entitled “SERVICE BRAKE – PARK BRAKE ADJUSTMENT”.

14

www.snapper.com

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Series Date of Purchase Retailer Retailers Phone Number Equipment EngineSnapper is a trademark Simplicity Manufacturing, IncTable of Contents Protection for Children Protection against TipoversPreparation Do not allow pre-teenage children to operate machineSafe Handling of Gasoline OperationMaintenance TowingFeatures and Controls Features and ControlsFuel Tank Operation Pre-Start Check List OPERATOR’S Seat AdjustmentFuel filler cap A, is tight, and the vent B is Operation Starting and Operation Engine Electric StartEngine runs smooth On Next OperationSetting the park brake Engine Manual StartMower Blade OperationWheel Drive Stopping Engine Wheel Drive, Blade Stop the engine by turning the key A, to the OFF positionCutting Height Adjustment Operation Stopping Engine, Wheel DriveBlade Park BrakeOperation Reverse Lockout Mechanism Reverse Lockout Mechanism OverrideAte blades in reverse. Stop BLADES, Look and see While backingService After the First 5 Hours MaintenanceIntroduction Service Brake / Park Brake Blade Drive Belt ReplacementCheck the Blade Drive Belt Blade BrakeSafety Interlock System Checks Check EngineReverse Lockout Mechanism Lubrication Grease FittingsService Every 25 Operating Hours Rear Axle Bearing Lubrication Engine ServiceDifferential / Chain Case Lubrication Service Annually Every Two YearsStorage Out of Season Removing the Fuel TankEngine Adjustments and Repair Mower Deck and Component AdjustmentsBlade Brake Adjustment Reinstall the belt cover and tighten the bolts securelyMower Deck Adjustment Side-To-Side Levelness Mower Deck Adjustment Front-to-Rear LevelnessMower Drive Belt Adjustment For 28 & 30 Decks Only Service BRAKE/PARK Brake AdjustmentMove the blade lever up and over to the on position To the rear main caseRear Engine Rider Drive Components Measurement should be 3/4Blade Wear Limits Mower Blade ReplacementSigns of excessive wear or damage Blade Sharpening Belt Replacement Do not attempt any adjustments, maintenance, service orTled Mower Drive Belt Adjustment Belt RemovalBattery Battery RemovalBattery Installation Slide the battery partially into the battery housingBattery Service Battery StorageNew Battery Preparation Battery TestingBattery Condition Chart Snapper Rear Engine Rider AccessoriesDescription of Kit Models Used on Maintenance Service Schedule SeasonMaintenance Maintenance/Replacement Parts Problem Probable Cause Corrective Action TroubleshootingStop Move lever to the on position Year Limited Warranty Slope Guide Page Page Page Page Common Service Parts Product Specifications 2811523BVSnapper Products Macon Street McDonough, GA

3317523BVE specifications

The Snapper 3317523BVE is a cutting-edge lawn mower designed to cater to homeowners who prioritize performance, efficiency, and ease of use in their gardening tools. This model stands out in the Snapper line for its robust engineering and innovative features, making it an excellent choice for residential lawn care.

One of the key features of the Snapper 3317523BVE is its powerful engine. Equipped with a reliable Briggs & Stratton engine, this mower delivers the necessary power for effective grass cutting, accommodating various grass types and conditions. The engine is not only powerful but also designed for fuel efficiency, allowing users to complete their mowing tasks without frequent refueling interruptions.

The Snapper 3317523BVE boasts a 21-inch cutting deck, which enhances maneuverability even in tight spaces. This compact size makes it suitable for urban and suburban lawns, where obstacles like flower beds and trees are common. Additionally, the cutting height is adjustable, with several settings available to allow for flexibility based on the grass type and weather conditions.

Another notable characteristic of the Snapper 3317523BVE is its innovative rear-wheel drive system. This feature significantly improves traction on slopes and uneven terrains, enabling users to maintain control over the mower, particularly in challenging mowing conditions. The wheels are designed for durability and stability, ensuring that they can handle the rigors of regular use.

The ergonomic handle design on the Snapper 3317523BVE adds to the overall user experience, allowing for comfortable operation. The handle can be adjusted for height, accommodating users of various sizes and preferences, while also providing a folding mechanism for easy storage.

Snapper's patented SmartChoke technology simplifies the starting process, reducing the hassle often associated with traditional mowers. This technology ensures a reliable start every time, even in varying weather conditions.

Moreover, the Snapper 3317523BVE's robust build is complemented by a sturdy plastic housing that is resistant to rust and corrosion, ensuring longevity and maintaining the mower's appearance over time.

Overall, the Snapper 3317523BVE is engineered to provide a seamless and efficient mowing experience, combining power, durability, and user-friendly features. This mower is a testament to Snapper's commitment to quality in the lawn care industry, making it a reliable choice for homeowners looking to maintain their gardens with ease.
Top Page Image Contents