General Operating Safety, Adding Fuel

Features & Controls

Catcher Open/Close Lever

The catcher open/close lever opens the catcher so that it may be emptied and closes it for mowing. To empty the catcher, depress the catcher dump lock pedal and pull forward on the handle. To close, push the lever back- ward until the catcher closes and locks.

12V Power Outlet

The power outlet is 12V-DC. Accessory must be rated at 14 amps or less.

Reverse Mowing Option (RMO)

The Reverse Mowing Option allows for mowing (or use of other PTO driven attachments) while traveling in reverse. If you choose to mow or operate another attachment in reverse, turn the RMO key after the PTO is engaged. The L.E.D. light will illuminate, and the opera- tor can then mow in reverse. Each time the PTO is dis- engaged the RMO needs to be reactivated if desired.

Operating the Tractor

GENERAL OPERATING SAFETY

STARTING THE ENGINE

Be sure to read all information in the Safety and Operation sections before attempting to operate this unit. Become familiar with all of the controls and how to stop the unit.

ADDING FUEL

To add fuel:

1.Remove the fuel cap (A, Figure 2).

2.Fill the tank. Do not overfill. Leave room in the tank for fuel expansion. Refer to your engine manual for specific fuel recommendations.

3.Install and hand tighten the fuel cap.

Do not use gasoline containing METHANOL, gasohol containing more than

10% ETHANOL, gasoline additives, or white gas because engine/fuel system damage could result.

WARNING

Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area. Avoid over-filling and wipe up any spills.

1.While sitting in the operator’s seat, fully depress the brake pedal or set the parking brake.

2.Make sure that your feet are not depressing the ground speed control pedals and that the cruise con- trol lever is in neutral.

3.Disengage the PTO clutch.

4.Close the choke.

NOTE: A warm engine may not require choking.

5.Insert the ignition key and turn it to START.

6.After the engine starts, move the engine throttle con- trol to SLOW. Warm up the engine by running it for at least a minute.

7.Set throttle to FULL.

NOTE: In the event of an emergency the engine can be stopped by simply turning the ignition switch to STOP. Use this method only in emergency situations. For nor- mal engine shut down follow the procedure given in

STOPPING THE TRACTOR.

STOPPING THE TRACTOR & ENGINE

1.Return the ground speed control(s) to neutral.

2.Disengage the PTO and wait for all moving parts to stop.

3.Place the throttle control in the position specified in the engine owner’s manual provided in the operator's packet shipped with your tractor. Follow any recom- mended stopping procedures.

4.Turn the ignition switch to OFF. Remove the key.