Snapper XL Series, 2400 XL Series, RD Series manual Attaching a Trailer, Storage

Page 17

ATTACHING A TRAILER

NOTE: Remove the hopper to attach a trailer.

The maximum horizontal drawbar force allowed is 444 Newton. The maximum vertical drawbar force is 222 Newton. This equates to a 396 lbs (180 kg) trailer on a 10 degree hill. Secure the trailer with an appropriately sized clevis pin (A, Figure 5) and clip (B).

STORAGE

WARNING

Never store the unit (with fuel) in an enclosed, poorly ventilated structure. Fuel vapors can travel to an ignition source (such as a furnace, water heater, etc.) and cause an explosion.

Fuel vapor is also toxic to humans and animals.

Before you store your unit for the off-season, read the Maintenance and Storage instructions in the Safety Rules section, then perform the following steps:

Disengage the PTO, set the parking brake, & remove the key.

Perform engine maintenance and storage measures listed in the engine owner’s manual. This includes draining the fuel system, or adding stabilizer to the fuel (do not store a fueled unit in an enclosed struc- ture - see above).

Battery life will be increased if it is removed, put in a cool, dry place and fully charged about once a month. If the battery is left in the unit, disconnect the nega- tive cable.

Before starting the unit after it has been stored:

Check all fluid levels. Check all maintenance items.

Perform all recommended check and procedures found in the engine owner’s manual.

Allow the engine to warm up for several minutes before use.

Operating the Tractor

A

 

B

 

396

Lbs.

(180kg)

3'4"

10˚

(1m)

 

20' (6m)

 

Figure 5. Trailer Weight Recommendations

A.Clevis Pin

B.Clip

15

Image 17
Contents OPERATOR’S Manual Page Table of Contents Safety Rules & Information Operating Safety Slope Operation Safety Rules and InformationGeneral Operation Safety Rules & InformationIgnition System Safe Handling of Gasoline Service & MaintenanceIdentification Numbers Identification NumbersSafety Decals Safety DecalsDecal Cutting Height Decal Transmission Release Decal Ignition PositionsOperational Safety Checks Safety IconsThrottle Control Throttle/Choke ControlHour Meter Optional Brake PedalFeatures & Controls Stopping the Tractor & Engine General Operating SafetyAdding Fuel Operating the Tractor Emptying the Catcher Parking Brake FunctionStorage Attaching a TrailerMuffler and surrounding areas may be hot Mower Deck Removal InstallationRemoving the Mower Deck Installing the Mower Deck Catcher Removal InstallationInstall Mulch Plug Discharge Mulch Plug Installation & Removal Some ModelsPage Fall Before Every SpringTransmission Maintenance Regular MaintenanceBattery Maintenance Check Tire PressuresOil LubricationLubricate Rear Axle Shafts Service Interval Yearly4x4 Wood Block Servicing the Mower BladesCheck Mower Blade Timing PTO Clutch Adjustment Check Safety Interlock System CheckEngine Maintenance SET Mower Belt TensionTroubleshooting, Adjustments, & Service Troubleshooting the Mower Hopper Latch Adjustment Seat AdjustmentPitch Adjustment Seat Slide AdjustmentBrake Adjustment Steering Gear AdjustmentAdjustment Nut NutsCATCHER-FULL Alarm Adjustment Troubleshooting, Adjustment, & ServiceMower Lift Adjustment Battery ChargingAdjust PTO Clutch Window Adjustment Nut Feeler Gauge PTO Clutch AdjustmentTransmission Release Lever Transmission PurgingLeveling The Mower Mower AdjustmentsCutting Height Adjustment Arbor Drive Belt Replacement PTO Belt ReplacementSpecifications Maintenance Items Replacement PartsOptional Accessories Technical ManualsPage O D U C T S