Operating the Tractor
| Snowthrower |
| & Dozer |
| Applications |
A |
|
B | F |
C | |
D | E |
| |
| Mower |
| Applications |
A |
|
B | F |
| |
G | E |
Figure 17. Lift Lock Plate - Hydraulic Lift Models
A.Lift Cylinder
B.Flat Head Pin (Original)
C.Flat Head Pin (New)
D.Lock Plate
E.Hair Pin Clips
F.Lift Shaft Assy.
G.Washers
Lift Variations When Using
Attachments
When a
Hydraulic Lift Models
Fully lower the hydraulic lift. The lift assembly is spring loaded so it will need to be held in the down position to perform of the following procedures.
When using a snowthrower or dozer, the downward pressure lock plate (D, Figure 17) and an additional pin
(C)is installed. These parts are included with the attach- ment. Note that the washers (G) are not used with the lock plate.
When mowing, the downward pressure lock plate (D) is removed and replaced with two washers (G). The addi- tional pin (C) is also removed.
Snowthrower
& DozerE
Applications
A
B | C | D |
Mower |
|
|
Applications |
| G |
A |
|
|
F C D
Figure 18. Lift Link - Manual Lift Models
A.Pin
B.Rear Hole of Lift Bar (Snowthrower Applications)
C.Spacer
D.Hair Pin Clip
E.Upper Hole (Snowthrower Applications)
F.Slot of Lift Link (Mower Applications)
G.Lower Hole (Mower Applications)
Manual Lift Models
NOTE: These instructions apply to Conquest / 1700 / 2700 / 400 Series tractors equipped with a lift lever kit.
The lift link is installed differently depending on what attachment is being used. Refer to Figure 18 for link installation information.
24