Snapper 2690628, 2690629 manual Attaching a Trailer, Storage, Volt Power Outlet

Page 25

OperatiflgtheTractor

Attaching a Trailer

The maximum weight of a towed trailer should be less than 800 Ibs (363 kg). Secure the trailer with an appro- priately sized clevis pin (A, Figure 23) and clip (B).

Excessive towed loads can cause loss of traction and loss of control on slopes. Reduce towed weight when operating on slopes. The surface being driven on greatly impacts traction and stability. Wet or slippery surfaces can greatly reduce traction and the ability to stop or turn. Carefully evaluate the surface conditions before operat- ing the tractor and trailer, and never operate on slopes greater than 10°. See SLOPE OPERATION and TOWED EQUIPMENT in the safety section of this manu- al for additional safety information.

Storage

WARNING

Never store the unit (with fuel) in an enclosed, poorly ventilated structure. Fuel vapors can travel to an ignition source (such as a furnace, water heater, etc.) and cause an explosion.

Fuel vapor is also toxic to humans and animals.

Before you store your unit for the off-season, read the Maintenance and Storage instructions in the Safety Rules section, then perform the following steps:

•Disengage the PTO, set the parking brake, and remove the key.

•Perform engine maintenance and storage measures listed in the engine owner's manual. This includes draining the fuel system, or adding stabilizer to the fuel (do not store a fueled unit in an enclosed struc- ture - see warning).

•Battery life will be increased if it is removed, put in a cool, dry place and fully charged about once a month. If the battery is left in the unit, disconnect the nega- tive cable.

Before starting the unit after it has been stored:

•Check all fluid levels. Check all maintenance items.

,,Perform all recommended checks and procedures found in the engine owner's manual.

•Allow the engine to warm up for several minutes before use.

I

®

10°

20" (6m)

Figure 23. Trailer Weight Recommendations

A. Clevis Pin

B. Clip

12 Volt Power Outlet

A CAUTION

Avoid injury. Safe operation requires your full attention. Do not wear radio or music headphones while operating machine.

The 12-volt accessory outlet is located in the left side pod. It can be used to power small electronic devices. The accessory must be rated at 14 amps or less.

Note: Operating a 12-volt accessory, especially with the engine at idle, may cause battery discharge. When not using the accessory outlet it must be covered with the

rubber plug to prevent moisture from causing a short cir- cuit. Entrance of water into outlet can cause a short cir-

cuit.

24

Page 24 Page 26
Image 25
Page 24 Page 26
Contents 27HP Hydro Tractors & Mower Decks 54 Mower Decks GT600 SeriesAbleof Contents OporatingSafety Meving SafetyRuJes& lflfomatJofl SafetyRulesandinformation Service & Maintenance Service and MaintenanceTracto Mower ID Tag JdefltificatioflNumbersDecal =Throttle Decal Transmission Safety DecalsPositions Decal =Attachment Lift Control Decal CuttingSafety icons Safetylcofls/ SafetyinteplockTestOperational Safety Checks Purpose of the safety interlock systemChoke Select lVlodels Control FunctionsFront A×Je Oil LeveJ Plug Features& Cofltrols Parking Brake Function Features& CefltrolsAutomatic Controlled Traction Irregular Voltage Dashboard Display FunctionsFuel Gauge Slope Operation General Operating SafetyAdding Fuel Starting The EngineMowing in Reverse OperatiflgtheTractorAttachment Operation in Reverse Wheel Drive OperationPushing The Tractor By Hand Using Inboard HydraulicsHydraulic System Functions GeneralAuxiliary Hydraulics Angle Left Angle Right Using Auxiliary HydraulicsAttachment Weight Limit Max. Attachment WeightOperatJflgtheTractor Locking The HitchHitch Arms Installation Checks Before Starting Connecting a Drive ShaftStarting & Stopping the PTO Engine Speed SelectionAttachment Recommendations PTO BOX Output Speed & Horsepower OutputRemoving the Mower Deck Mower Deck Removal & installationMower Electrical Connection Installing the Mower DeckAttaching a Trailer Volt Power OutletStorage Every Safety iTEMSHours UseClean Transmission Oil Cooler Clean RadiatorCheck Engine Coolant Level Change Engine CoolantDrain Fuel Separator RegularMaintenanceTransmission Fluid Check Dip Stick Check Transmission Oil LevelCheck Front Axle Oil Level Change Transmission Oil & filter17ram Drain Plug Check Mower Deck Gear Box Oil Safety Interlock System CheckBlade Brake Check Cleaning the Battery and CabJes Battery MaintenanceCheck Tire Pressures Size Tread PSiEvery 25 Hours LubricationGrease Deck Lubrication Every 10 Hours Injury Servicing The Mower BladesSpring Washer Capscrew RegularlVlaifltenance Engine will not turnover or start Troubleshooting, Adjustment,& ServiceTractor Troubleshooting Cont TroubJeshootin9oAdjustment,& ServiceMower will not raise Seat Adjustment TrouhJeshooti&q,Adjustment,& ServiceSeat Slide Adjustment Headlight Replacement Teouhleshootin9oAdjustment,& ServiceTaillight & Dash Light Replacement Mower Adjustments TroubJeshooti&j,Adjustment,& ServiceGauge Wheel Adjustment Hair Pin Upper PositionSpacer Leveling The MowerMower Belt Replacement TpouhJeshootin9oAdjustment,& ServiceMower Drive Belt Replacement Drive Idler Center4WD DiMENSiONS27 HP Briggs Stratton Maintenance Items Replacement Parts TechnicalAccessories Manuals

2690629, 2690628 specifications

Snapper 2690628 and 2690629 are innovative lawn care solutions that have gained significant attention in the outdoor equipment market. These models are designed for homeowners who seek efficiency and reliability in their lawn maintenance routine. Featuring powerful engines and cutting-edge technology, they stand out as top contenders for those who prioritize performance and ease of use.

One of the main features of the Snapper 2690628 and 2690629 is their robust engine performance. Both models are equipped with reliable Briggs & Stratton engines that provide ample power for tackling dense grass and tough terrain. This ensures that users can complete their mowing tasks quickly and efficiently, with minimal effort required.

These mowers are designed with ease of use in mind. The intuitive controls and ergonomic design allow for comfortable handling during extended mowing sessions. The push-button start feature eliminates the hassle of pulling cords, making it easier for users to get started. Furthermore, the adjustable cutting height feature gives users the versatility to achieve their desired grass length, whether they prefer a golfing green finish or a more natural look.

Another noteworthy technology is the mulching capability featured in both models. The Snapper 2690628 and 2690629 can effortlessly convert grass clippings into fine mulch. This not only reduces yard waste but also returns valuable nutrients to the soil, promoting a healthier lawn. Additionally, the side discharge option allows for efficient grass disposal, making it suitable for various mowing preferences.

Durability is another significant characteristic of the Snapper 2690628 and 2690629. Both models feature a sturdy steel deck that withstands the rigors of outdoor use, ensuring longevity. The rust-resistant finish further enhances their lifespan, allowing users to enjoy the benefits of their mowers for years to come.

In conclusion, the Snapper 2690628 and 2690629 represent a remarkable combination of power, technology, and user-friendly features. With their reliable engines, ergonomic designs, and practical mowing capabilities, they are ideal choices for homeowners looking to maintain a pristine lawn effortlessly. These models not only prioritize performance but also emphasize comfort and durability, making them valuable additions to any lawn care arsenal.
Top Page Image Contents