La Crosse Technology WS-9075U VII. Adding Remote Temperature Sensors Optional, Outdoor LCD

Page 14

VII. ADDING REMOTE TEMPERATURE SENSORS (OPTIONAL)

The WS-9075U is able to receive signals from 3 different remote temperature sensors. The remote temperature sensor model(s) that you choose will come with their own set of instructions—follow these instructions for a complete guide to setting up. Following are some brief instructions for the basic set-up of remote temperature sensor units with the WS-9075U. These extra sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. A TX6U will monitor temperature only, a TX3U will monitor temperature and display the temperature on its LCD, and the TX3UP will monitor the temperature via a probe for use in pools, spas, etc.

Note: When setting up multiple units it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the remote temperature sensor units, and in numeric sequence. Second install batteries into the indoor weather station. Transmission problems will arise if this is not done correctly and if the total time for set-up exceeds 4 minutes.

A. SET-UP OF MULTIPLE UNITS

1.It is necessary to remove the batteries from all units currently in operation.

2.Remove the battery covers to all remote temperature sensor units.

3.Place all remote temperature sensor units in a numeric sequential order.

4.In sequential order, install batteries (follow the same battery installation procedures seen in section I. A) of the Detailed Set-UpGuide).

5.Install batteries into the indoor weather station.

6.Follow the Detailed Set-Up Guide for programming and operating instructions.

B.VIEWING AND OPERATING WITH MULTIPLE REMOTE TEMPERATURE SENSOR UNITS

1. To view the temperature of a different remote temperature sensor unit, press and release the CHANNEL button. A shift from one “boxed” number to the next should be observed in the

OUTDOOR LCD.

2. To view the Minimum/Maximum temperature: first select which remote temperature sensor to read data from (indicated by the “boxed” number), then press the MIN/MAX/+ button. To view the readings from different transmitters, follow IV. A. Viewing the Outdoor Temperature Records paragraph above.

3. To reset the Minimum/Maximum readings, select first which remote temperature sensor to read data from. Press the MIN/MAX/+ button to view the outdoor MIN/MAX records. Then follow the steps in IV. C. Resetting the Minimum and Maximum Records paragraph above.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents WS-9075U Table of Contents Inventory of Contents Important Notes on Set-up and Operation Quick SET-UP GuideDo not Press ANY Buttons for 15 Minutes Indoor Weather Station II. Setting the LCD Contrast Program ModeProgramming Sequence and Default Settings II. Function KeysIII. Time Zone Setting IV. Daylight Saving Time DST SettingVII. Time Setting RADIO-CONTROLLED Time ON/OFF SettingVI or 24 Hour Time Setting Wwvb Remote Control TimeIX. Selecting F or C VIII. Setting the YEAR, DAY and MonthSetting the Forecast Sensitivity Time LCDXI. Setting the Animation Forecast Icons and Stars Features of the WS-9075UWeather Icons II. Outdoor TemperatureWeather Forecast Weather Tendency ArrowsViewing the Indoor Temperature and Humidity Records IV. Minimum and Maximum Temperature and Humidity RecordsViewing the Outdoor Temperature Records Resetting the Mimimum and Maximum RecordsTime Alarm Outdoor Channel RE-LEARN ModeMoon Phase Outdoor LCD VII. Adding Remote Temperature Sensors OptionalSET-UP of Multiple Units Mounting with Adhesive Tape Mounting Remote Temperature SensorMounting with Screws Troubleshooting Foldout Table StandMaintenance and Care Instructions SpecificationsFCC Disclaimer
Top Page Image Contents