La Crosse Technology WS-9075U instruction manual Indoor Weather Station

Page 5

DETAILED SET-UP GUIDE

BATTERY INSTALLATION

A. REMOTE TEMPERATURE SENSOR

1.Remove the mounting bracket. The bracket snaps on and off easily.

2.Remove the battery cover, by sliding the cover down.

3.Observing the correct polarity install 2 AA batteries. The batteries will fit tightly (to avoid start-up problems make sure they do not spring free).

4.Replace the battery cover by sliding upwards. Be sure battery cover is on securely.

B. INDOOR WEATHER STATION

1.Remove the battery cover. To do this, insert a solid object in the space provided at the lower-central position of the battery cover, then push up and pull out on the battery cover.

2.Observe the correct polarity, and install 3 AA batteries.

3.Replace the battery cover.

Note: Immediately after the batteries have been installed, the LCD (Liquid Crystal Display) will flash. Within 15 seconds the indoor temperature, indoor relative humidity, and the weather icons (sun and clouds) will be displayed. If not, remove batteries for 10 seconds and reinstall. If the outdoor temperature is not displayed within

four minutes, remove batteries from both units, wait 30 seconds, and reinstall making sure to install batteries into the remote temperature sensor first. The time will show 12:00 and start searching for the WWVB signal. If it successfully receives the time signal (usually at night), it will display the correct time (default time-zone is Eastern). You will need to adjust the time zone to match your local time.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents WS-9075U Table of Contents Inventory of Contents Important Notes on Set-up and Operation Quick SET-UP GuideDo not Press ANY Buttons for 15 Minutes Indoor Weather Station Programming Sequence and Default Settings Program ModeII. Setting the LCD Contrast II. Function KeysIV. Daylight Saving Time DST Setting III. Time Zone SettingVI or 24 Hour Time Setting RADIO-CONTROLLED Time ON/OFF SettingVII. Time Setting Wwvb Remote Control TimeSetting the Forecast Sensitivity VIII. Setting the YEAR, DAY and MonthIX. Selecting F or C Time LCDFeatures of the WS-9075U XI. Setting the Animation Forecast Icons and StarsWeather Forecast II. Outdoor TemperatureWeather Icons Weather Tendency ArrowsViewing the Outdoor Temperature Records IV. Minimum and Maximum Temperature and Humidity RecordsViewing the Indoor Temperature and Humidity Records Resetting the Mimimum and Maximum RecordsTime Alarm Outdoor Channel RE-LEARN ModeMoon Phase Outdoor LCD VII. Adding Remote Temperature Sensors OptionalSET-UP of Multiple Units Mounting with Adhesive Tape Mounting Remote Temperature SensorMounting with Screws Foldout Table Stand TroubleshootingSpecifications Maintenance and Care InstructionsFCC Disclaimer
Top Page Image Contents