Install Batteries, Setup | Acu-Rite 00614/00626SB specification

2 • OVERVIEW OF FEATURES - RAIN COLLECTOR

Removable Debris Screen

The Debris Screen prevents leaves and sticks from entering into the rain collector. Remove and clean debris periodically to ensure collector accuracy.

Removable Rain Collector Funnel

The Funnel is specially designed with a large 6” opening to maximize the rain collection area.

The funnel is removable for easy cleaning. To remove, simply rotate the funnel in either direction and pull out.

Remove Packing Material

The Rain Collector and Rain Collector Tipping Bucket are packaged with a protective material inserted to prevent excessive movement during shipping. Carefully remove all of these materials and discard them.

Collector Upper Casing

The Collector Upper Casing encloses the sensor/battery compartment component and seals the collection tipping bucket from wind and non-metered rain drops. To remove upper casing from lower casing, press inward on side tabs and lift up carefully.

Battery Compartment & Electronics Box

The Battery Compartment & Electronics Box component of the rain collector slides into place on slots and encases the batteries and other electronics components. To remove this component, squeeze the two tabs and gently slide the box out. Take care that the box is re-installed in the correct manner (with the batter compartment cover facing the outside of the Upper Casing) when slid back in.

3 • SETUP

Install Batteries

NOTE: Install all batteries in both units within a 6 minute period to ensure proper wireless functionality.

A. Rain Collector Always install batteries into the rain collector FIRST to ensure proper wireless synchronization with the main unit.

1)Separate the upper and lower casing of the rain collector.

2)Remove the battery compartment & electronics box. Remove the now loose battery compartment cover and install 2 fresh “AA” batteries as shown here.

A B C

COMPARTMENTBATTERY

COVER

Tapa del

compartimiento de las baterías

Rain Collection Tipping Bucket

The Rain Collection Tipping Bucket collects a metered amount of rain and tips to automatically empty, allowing for continuous rain measurement.

Collector Lower Casing Base

The Collector Lower Casing Base supports the entire rain gauge and also serves as a mounting base. It is very important that the base be placed on a flat, level surface for proper operation.

- 2 -

	B. Main Unit	INSTALL
	Remove the battery	3 “AA”
	Remove the battery	BATTERIES
	compartment cover and	BATTERIES
	compartment cover and
	install 3 fresh “AA”
	batteries as shown here.

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.

BATTERY SAFETY: Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

- 3 -