Troubleshooting
Problem | Possible Solution | |||||
|
|
|
|
|
| |
|
|
|
|
| Relocate the main unit and/or the wireless | |
Bad Rain Collector | rain collector closer together. Both units must | |||||
be within 100 feet from each other. Make sure | ||||||
Reception | both units are placed at least 3 feet from other | |||||
electronic appliances and devices that may | ||||||
|
|
|
|
| ||
|
|
|
|
| interfere with the wireless communication | |
|
|
|
|
| ||
|
|
|
|
| (such as TV’s, microwaves, computers etc.). | |
no bars | ||||||
NOTE: It may take up to 20 minutes for the | ||||||
|
|
|
|
| ||
|
|
|
|
| main unit to | |
|
|
|
|
| when batteries are replaced. | |
|
|
|
|
|
| |
|
|
|
|
| If you suspect the rainfall measurement is | |
|
|
|
|
| not accurate, make certain the rain collector | |
|
|
|
|
| batteries are fresh. | |
Suspected Rain | Check that the collector is mounted to a | |||||
Measurement | level surface and that no foreign debris or | |||||
Inaccuracy | plant matter is preventing the flow of rainfall | |||||
into the collector. See “Care Instructions.” | ||||||
|
|
|
|
| ||
|
|
|
|
| Make certain that the internal tipping bucket | |
Set Wireless ID
This wireless rain gauge uses long range 433mhz radio frequency for communication.
In the event that you have reception problems due to interference, both the main unit and the wireless rain collector have a selectable wireless ID. The ID switches are located within the battery compartments of the main unit and the wireless rain collector.
You may choose A, B or C; but both the main units’ and the wireless rain collectors’ IDs must match for successful synchronization.
A B C |
Battery |
Compartment |
Cover |
A B CA B C
both wireless ID’s
must match
| is allowed to move freely and is not obstructed | |
| by any foreign objects or debris. | |
|
| |
No Rain Data | If wireless reception is bad (no bars), see | |
“Bad Reception” section above. The wireless | ||
Recorded On Main Unit | ID setting on each unit must match for both | |
(no communication) | units to communicate properly. See “Set | |
Wireless ID” on the next page. | ||
| ||
|
| |
Main Unit | Make certain that the batteries are installed | |
Display Not Working | correctly. The batteries may need replacing. |
Product Registration
To receive product information, register your product online. It’s quick and easy!
Log on to http://www.chaneyinstrument.com/product_reg.htm
- 8 -
6 • PRODUCT SPECIFICATIONS
Measurement Ranges
Rainfall
Accumulative Rainfall Range: 0 to 99.99 inches ( 0 to 2540 mm )
Specifications
Rain Gauge General Specifications
Rainfall Resolution: 0.02 inches
Rainfall Units: Inches (in) and millimeters (mm)
Wireless Rain Collector: automatic self emptying, continuous rainfall measuring
Power Requirements
Main Unit: 3 x “AA” alkaline or lithium batteries
Wireless Rain Collector: 2 x “AA” alkaline or lithium batteries
Wireless Communication
Radio Frequency: 433 mhz
Transmission Intervals: every 16 seconds
- 9 -