Cub Cadet 7254 manual Front of Engine, Using a fuel stabilizer, Emptying the fuel system

Page 40

Using a fuel stabilizer:

•Read the product manufacturer’s instructions and recommendations.

•Add to clean, fresh gasoline the correct amount of stabilizer for the capacity (approximately 6 gallons) of the fuel system.

•Fill the fuel tank with treated fuel and run the engine for 2-3 minutes to get stabilized fuel into the carburetor.

Emptying the fuel system:

•Prior to putting the tractor in storage, monitor fuel consumption with the goal of running the fuel tank empty.

•If a large volume of fuel is left-over, the fuel line can be disconnected at the fuel filter and the leftover fuel drained into an approved container.

•Run the engine until it begins to stall. Use the choke to keep the engine running until all fuel in the carburetor has been exhausted.

•Place a small container or rag beneath the carburetor bowl drain and loosen the drain screw to completely drain the fuel from the carburetor. See Figure 48.

FRONT OF ENGINE

CARBURETOR

BOWL

DRAIN

SCREW

CARBURETOR

BOWL DRAIN

LEFT VALVE

COVER

Figure 48

3.Clean the engine and the entire tractor thoroughly.

4.Drain and flush the cooling system. Refill with a minimum 50/50 antifreeze and water coolant solution. Use a higher percentage of antifreeze if the tractor will be subjected to temperatures below minus 30° F.

5.Fully charge the battery, then disconnect the negative cable at the battery to prevent possi- ble discharge. Thoroughly clean the battery. Recharge the battery periodically when in stor- age.

NOTE: Remove the battery if exposed to pro- longed periods of sub-freezing temperatures. Store in a cool, dry location where tempera- tures are above freezing.

6.Lubricate all lubrication points.

7.Jack up and block the tractor to remove the weight from the tires if stored for a long period. If not blocked up, reinflate the tires regularly.

NOTE: We do not recommend the use of a pressure washer or garden hose to clean your unit. They may cause damage to electrical components; spindles; pulleys; bearings; or the engine. The use of water will result in shortened life and reduce serviceability.

REMOVING THE TRACTOR FROM STORAGE

•Check the engine oil and coolant levels.

•Fully charge the battery and inflate the tires to the recommended pressure.

•Start the engine and allow to idle for a few minutes to ensure engine is operating properly.

•Drive the tractor without a load to make certain all the tractor systems are functioning properly.

40

Page 39 Page 41
Image 40
Page 39 Page 41
Contents Important Read Safety Rules and Instructions Carefully Operator’s ManualPage Calling Service Information Table of ContentsTo the Owner Tractor Model Plate Recording Model and Serial Number InformationRops Information Plate Important Safe Operation Practices General OperationSlope Operation ChildrenOperating the PTO Do notSafety Frame Rops ServiceSafety Labels Starting AIDFAN Warning Label Located on Each Side of Radiator Keep HandsPTO Warning Label Located on Rear PTO Shield Battery Warning Label Located Under HoodRoll Over Warning Label Located on RIGHT/REAR Fender Controls and Features Floorboard and Dash Panel Mounted ControlsPTO Switch Ignition SwitchSeat Adjustment Lever Steering WheelHazard Light Switch Headlight SwitchDifferential Lock Pedal Parking Brake LeverBattery Indicator Light Engine Coolant Temperature LightParking Brake Indicator Light PTO Indicator LightFender Mounted Conrtols and Features PTO Reverse Override SwitchFuel Fill Cap PTO Selection LeverTransmission Hi/Lo Range Shift Lever Cup HolderHand Holds Amber Hazard LightsSafety Interlock System OperationRollover Protective Structure Rops Fueling the TractorStarting the Engine NEW Tractor BREAK-IN ProceduresCold Weather Starting Using Jumper Cables to Start the Engine Stopping the EngineDriving the Tractor Driving on SlopesUsing the HI/LO Range Shift Lever Using the FORWARD/REVERSE PedalStopping the Tractor Using the Differential Lock Pedal Using the Hydraulic Lift LeverUsing the PTO Selection Lever Engaging the PTOUsing the PTO Reverse Override Switch Using the Hitch PlateUsing the Three Point Hitch LightingTractor Weighting On Demand Four Wheel DriveAdjustments Adjusting the SeatAdjusting the Seat Belt Three Point Hitch AdjustmentsAdjusting Front Wheel TOE-IN Check the TOE-IN AS FollowsAdjusting the Brakes Adjusting Hydraulic Lift Feedback RODLubrication Table MaintenanceGeneral Information 11 5 Lubrication and Maintenance Chart Operation to Service Intervals Be PerformedAccessing the Engine Compartment General Battery InformationBattery Maintenance Battery RemovalBattery Storage Tail Light Bulb Replacement Head Light Bulb ReplacementHazard Bulb Replacement Instrument Panel Bulb Replacement Accessing the Fuse CenterServicing Electrical System Instrument Panel FusesHazard Light Flasher Relay Main FuseChecking TRANSMISSION/HYDRAULIC System OIL Level Changing TRANSMISSION/HYDRAULIC System OIL Initial Break-In Period Filter Change Check Final Reduction Gear Case Oil Check Front Axle OilChanging Front Axle and Final Reduction Gear Case OIL Maintenance of the Rollover Protective Structure Rops Lubrication of Main Drive ShaftLubrication of FWD Drive Shaft Wheel Bolt TorqueTractor Storage Tire MaintenanceIf storing the tractor for 30 days or more Using a fuel stabilizer Front of EngineEmptying the fuel system Removing the Tractor from StorageEngine Information and Maintenance Limited Liability Engine Maintenance Cleaning the EngineCleaning the Radiator Screen and Radiator Before servicingAdding Engine OIL Changing the Engine OIL and FilterChecking Engine Coolant Level Inspection of Cooling System Hoses Changing the AIR CleanerChanging the Engine Coolant Servicing the Foam Precleaner Servicing the Paper ElementServicing the Spark Plugs Changing the Fuel FilterSpecifications Power Take-Off General DimensionsHydraulic Lift System BrakesOptional Equipment and Accessories DescriptionPage CUB Cadet LLC Post Office BOX CLEVELAND, Ohio
Top Page Image Contents