Cub Cadet 2176 manual II. Slope Operation, Do not, III. Children

Page 5

13.Mow only in daylight or good artificial light.

14.Do not operate the machine while under the influence of alcohol or drugs.

15.Watch for traffic when operating near or crossing roadways.

16.Use extra care when loading or unloading the machine into a trailer or truck. This unit should not be driven up or down a ramp onto a trailer or truck under power, because the unit could tip over causing serious personal injury. The unit must be pushed manually on a ramp to load or unload properly.

17.Never make a cutting height adjustment while the engine is running if the operator must dismount to do so.

18.Wear sturdy, rough-soled work shoes and close- fitting slacks and shirts. Do not wear loose fitting clothes or jewelry. They can be caught in moving parts. Never operate a unit in bare feet, sandals or sneakers.

19.Check overhead clearance carefully before driving under power lines, wires, bridges or low hanging tree branches, before entering or leaving buildings, or in any other situation where the operator may be struck or pulled from the unit, which could result in serious injury.

20.Disengage all attachment clutches, thoroughly depress the brake pedal and shift into neutral before attempting to start the engine.

21.Your mower is designed to cut normal residential grass of a height no more than 10”. Do not attempt to mow through unusually tall, dry grass (e.g. pasture) or piles of dry leaves. Debris may build up on the mower deck or contact the engine exhaust presenting a potential fire hazard.

22.Use only accessories approved for this machine by Cub Cadet. Read, understand and follow all instructions provided with the approved accessory.

II. SLOPE OPERATION

Slopes are a major factor related to loss of control and tip-over accidents, which can result in severe injury or death. All slopes require extra caution. If you cannot back up the slope or if you feel uneasy on it, do not mow it.

For your safety, use the slope gauge included as part of this manual to measure slopes before operating this unit on a sloped or hilly area. If the slope is greater than 15° as shown on the slope gauge, do not operate this unit on that area or serious injury could result.

DO:

Mow up and down slopes, not across.

Remove obstacles such as rocks, limbs, etc.

Watch for holes, ruts or bumps. Uneven terrain could overturn the machine. Tall grass can hide obstacles.

Use slow speed. Choose a low enough gear so that you will not have to stop or shift while on the slope. Al- ways keep the machine in gear when going down slopes to take advantage of engine braking action.

Follow the manufacturer’s recommendations for wheel weights or counterweights to improve stability.

Use extra care with grass catchers or other attach- ments. These can change the stability of the machine.

Keep all movement on the slopes slow and gradual. Do not make sudden changes in speed or direction. Rapid engagement or braking could cause the front of the machine to lift and rapidly flip over backwards, which could cause serious injury.

Avoid starting or stopping on a slope. If the tires lose traction, disengage the blades and proceed slowly straight down the slope.

DO NOT:

Do not turn on slopes unless necessary; then, turn slowly and gradually downhill, if possible.

Do not mow near drop-offs, ditches or embankments. The mower could suddenly turn over if a wheel is over the edge of a cliff or ditch, or if an edge caves in.

Do not mow on wet grass. Reduced traction could cause sliding.

Do not try to stabilize the machine by putting your foot on the ground.

Do not use the grass catcher on steep slopes.

III. CHILDREN

Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to the machine and the mowing activity. Never assume that children will remain where you last saw them.

1.Keep children out of the mowing area and in watchful care of an adult other than the operator.

2.Be alert and turn the machine off if children enter the area.

3.Before and when backing up, look behind and down for small children.

4.Never carry children, even with the blades off. Children may fall off and be seriously injured or may interfere with safe machine operation.

5

Image 5
Contents OPERATOR’S Manual Important Read Safety Rules and Instructions CarefullyMANUFACTURER’S Warranty Coverage Tractor and Deck Preparation ContentsGeneral Operation Safe Operation PracticesIII. Children II. Slope OperationDo not IV. Service Product Graphics Deflector and Safety GraphicSerial Number Location To the OwnerSafety Interlock Switches Not Shown Section I. Controls and IndicatorsPower TAKE-OFF PTO Control Switch LOW OIL IndicatorIGNITION/LIGHT Switch Hour MeterSeat Adjustment Lever Lift Height IndicatorBrake Pedal Forward Control PedalHood and Side Panels Safety Interlock SwitchesFuel Tank Page Starting the Engine Section II. OperationBefore Operating Your Tractor Cold Weather Starting Tractor BREAK-IN ProcedureStopping the Engine Driving the Tractor Driving on Slopes Operating the Power TAKE-OFF PTO ClutchStopping the Tractor DrawbarAdjusting the Brakes Section III. AdjustmentsAdjusting the Seat Wheel Alignment Front Wheel AdjustmentPivot BAR Adjustment Checking the Transmission Neutral Setting Hydrostatic Neutral AdjustmentFront Control Rod Rear Control Rod Hex Tap Screw Adjusting Lift Assist Spring TensionControl Pivot Sleeve Neutral ArmCarburetor Adjustments Engine Maintenance Section IV. MaintenanceEngine OIL Checking the OIL LevelDraining OIL and Replacing OIL Filter Adding OILFilling the Crankcase Hydrostatic Drive OIL Filter Checking Transmission OIL LevelAdding Transmission OIL Servicing the Precleaner AIR CleanerElement Cover Air Cleaner Base Rubber Grommet Air Cleaner Cover Paper Element Wing NutCleaning Engine Servicing the Paper ElementHeadlights Spark PlugFuel Filter Maintenance of Battery General Battery InformationStorage of the Battery Common Causes for Battery FailureBattery Removal Battery Removal or InstallationBattery Installation Wash Hands after handlingMounting Tires on the RIM TiresTire SizePounds per Square Inch Section V. Mower Deck SIDE-TO-SIDE Leveling AdjustmentFinger guard Blade Hard Level Surface Measure This Distance Front to Back Leveling AdjustmentGauge Wheel Adjustment Flat Cutting Height AdjustmentWasher Rear Gauge WheelRemoval of Deck Removal and Installation of Deck AssemblyFront Lift ROD Roller Bracket Installation of Deck Front Roller Bracket Lift ROD Install the forward end of the PTO belt on the PTO Cleaning and Blade Care MaintenanceLubrication Spindle Drive Belt Replacement Installation of Mulching PlugSection VI. OFF-SEASON Storage Mowing with Mulching Option Section VII. MowingMowing Optional Equipment and Accessories Month Season Yearly Storage Maintenance ChartPTO Clutch will not Engage Hard to StartEngine Operates Irregularly or Knocks Lack of Power Trouble ShootingMaintenance NanceLubrication Table Lubrication Guide Lubrication Guide Guide Engine SpecificationsPage Slope Gauge Commercial USE Residential USE CUB Cadet Corporation MANUFACTURER’S Limited WarrantyMaintenance Parts Chart

2176 specifications

The Cub Cadet 2176 lawn tractor is a powerhouse in the realm of residential lawn care, designed to provide users with enduring performance and exceptional features. Known for its reliability and user-friendly operation, this model combines power, comfort, and innovative technology, making it a preferred choice among homeowners.

At the heart of the Cub Cadet 2176 is its robust 17-horsepower Kohler engine. This engine not only ensures ample power for mowing but also handles larger lawns with ease. The hydrostatic transmission allows for smooth operation, offering easy speed adjustments without the need for shifting gears. This feature is particularly beneficial for those who need to navigate around obstacles or work in tighter spaces.

One of the standout characteristics of the Cub Cadet 2176 is its 42-inch cutting deck. This wide cutting path allows users to cover more ground in a shorter amount of time, making lawn maintenance more efficient. The deck is equipped with a washout port, enabling easy cleaning after use, which prolongs its lifespan and ensures optimal performance.

Comfort is a key consideration in the design of the 2176. The lawn tractor features a comfortable, adjustable seat that allows for prolonged use without discomfort. Additionally, the operator's presence control (OPC) ensures that the tractor stops when the operator leaves the seat, improving safety during operation.

Moreover, the Cub Cadet 2176 incorporates the company’s signature Cadet Smart technology, providing users with enhanced diagnostics and maintenance reminders. This technology enables users to monitor the tractor’s performance and receive alerts for maintenance tasks, ensuring that the machine runs efficiently year-round.

Another notable feature is the ease of use. The controls are strategically placed for simple access, allowing for intuitive operation. The tractor also supports a variety of attachments, including baggers, mulchers, and snow plows, making it a versatile choice for year-round functionality.

In conclusion, the Cub Cadet 2176 lawn tractor stands out for its blend of power, comfort, and advanced technology. With its powerful engine, efficient cutting deck, user-friendly controls, and innovative features, it is a reliable companion for maintaining a beautiful lawn. Whether dealing with weekly mowing duties or seasonal tasks, the Cub Cadet 2176 meets the demands of modern homeowners seamlessly.