LUBRICATIONGUIDE
International Cub Cadet 108, 149, and 169 Tractors
1.Oil filler cap and
Steeringknuckes(2).3.
Front axle pivot pin.
Transmission oil filter.
Check the oil (with the engine stopped) and add sufficient new oil to bring it to the "FU LL" mark on the gaugE:.Do not overfill. Do not operate the engine if the oil level is below the "LOW" mark on the gauge.
Use IH 251 H EP grease or equivalent #2
NOTE: After the first 10 hours only, remove the old filter and replace with a new filter as instructed on page 35. Change the oil filter after 50 hours and every 100 hours of operation thereafter.
While the oil is warm, remove the drain plug (5) and drain all of the oil from the crankcase. Replace the drain plug.
Remove the crankcase oil filler cap (1). Refill the
Engine crankcase.crankcase with new oil up to the "FULL" mark on the oil
level gauge. Refer to the "Lubrication Table" for the proper quantity and viscosity to use.
Transmission oil filter.
7. Transmission oil filter.
Transmission
Oil level and filler plug
NOTE: After the first 50 hours only, remove the old filter and replace with a new filter as instructed on page 35. Change the oil filter every 100 hours of operation thereafter.
Change the oil filter and replace with a new filter as instructed on page 35.
Check the oil level periodically. Keep the lubricant up to the level plug (8) on the rear of the transmission casecove
40
28654.