•Using Mixed Control — In draft control, when draft decreases, the implement automatically lowers to increase draft. However, the implement some- times lowers too much. To limit the degree the implement can be lowered, set the position control lever at the lowest working depth desired for the implement; then lower the draft control lever to the point where the implement is at the desired depth. This stops the implement from going too deep and also controls the pull to prevent loss of traction and ground speed.
Brake Pedal Lock
The brake pedal lock is located on the right brake pedal. Flip the lock counterclockwise so it engages the bracket on the left brake pedal to interlock both brake pedals. See Figure 18.
Engage | Disengage |
|
SEAT ADJUSTMENT LEVER
Figure 19
PTO Safety Switch
Located on the right fender. To stop the PTO in an emergency, depress the switch. The switch must be pressed a second time (switch button in the up position) to
ON
- On
BRAKE
PEDAL
LOCK
Figure 18
Seat Adjustment Lever
The seat adjustment lever is located beneath the left side of the seat. This lever is used to adjust the seat forward or backward to the desired operating position. See Figure 19.
OFF- Off
PTO
SAFETY
SWITCH
Figure 20
19