SECTION 1: CONTROLS AND FEATURES
SWITCHES AND DASH MOUNTED CONTROLS
J
HB
C
D
F
I
E
A
G
Figure 1
A. | Ignition Switch | F. | Steering Tilt Lock Lever |
B. | Light Switch | G. | Parking Brake Lever |
C. | Turn Signal Switch | H. | Forward/Reverse Shift Lever |
D. | Hazard Lamp Switch | I. | Hand Throttle Lever |
E. | PTO Switch | J. | Instrument Panel |
A. Ignition Switch
NOTE: To prevent accidental starting and/or battery discharge, remove the key from the ignition switch when the tractor is not in use.
The ignition switch has four positions turning clockwise as follows (Refer to Figure 2):
OFF - The engine and electrical system is turned off.
ACC - Energizes the accessory circuit.
ON/HEAT - Energizes the tractor’s electrical system. Warning lamps on the instrument panel are momentarily illuminating to test the system. Engine glowplugs are also energized to preheat the combustion chamber.
START - Activates the starter motor to turn over and start the engine. When the engine starts release the key immediately and it will return to the ON position.
NOTE: The safety circuit will prevent the starter from turning if the clutch pedal is not depressed.
Start
On/Heat
IGNITION
SWITCH
Off
Figure 2
12