Cub Cadet 8354 manual Transmission OIL and OIL Filter, Checking the Transmission Oil Level

Page 40

TRANSMISSION OIL AND OIL FILTER

Checking the Transmission Oil Level

Check the hydro transmission/hydraulic system oil level before each use. Check the oil level only while the engine is stopped and the tractor is standing on a level surface.

•Locate the transmission dipstick on the top/rear of the transmission at the back of the tractor. See Figure 59.

Breather Cap

Dipstick

Fill Tube

Figure 59

•Clean the area around the dipstick to prevent debris from entering the transmission; then with- draw the dipstick from the transmission and wipe clean.

•Fully re-insert the dipstick into the transmission.

•Withdraw the dipstick again, and check the oil level. Always keep the oil level between the full and add marks on the dipstick.

•If the oil level is low, refer to the LUBRICATION TABLE for the proper type and quantity of oil to add to the transmission.

•Clean the area around the breather cap and fill tube on the back of the transmission to prevent debris from entering the transmission . Then turn the cap counterclockwise to unscrew from the oil fill tube. Refer to Figure 59.

•Slowly pour transmission oil into the fill tube while frequently checking the oil level with the dipstick. Add only enough oil to bring the oil level up to the full mark on the dipstick.

•Screw the breather cap into the fill tube, and reinsert the dipstick into the transmission and press firmly into place.

Changing the Transmission Oil and Filter

The oil in the transmission case is also used for the hydraulic system. The transmission/hydraulic oil and the oil filter (located on right side of tractor) should be changed after the first 50 hours of operation, then at 300 hours and every 300 hours thereafter. Refer to the LUBRICATION TABLE for the quantity and type of oil needed.

•Clean the area around the transmission dipstick and breather cap to prevent debris from entering the transmission. Refer to Figure 59.

•Locate the drain plug on the bottom of the transmission. Place a suitable container below the drain plug to collect the old oil. See Figure 60.

Transmission

Drain Plug

Figure 60

•Remove the dipstick and breather cap from the transmission.

•Turn the drain plug counter-clockwise to remove from the transmission, and allow the old oil to completely drain from the transmission. NOTE: The capacity of the transmission is approximately 11.6 gallons (46.4 qts.), so it may be necessary to drain the transmission in stages to capture the used oil and/or to ease emptying the drain pan.

40

Page 39 Page 41
Image 40
Page 39 Page 41
Contents Important Read Safety Rules and Instructions Carefully Operator’s ManualCalling Service Information Table of ContentsTo the Owner Tractor Recording Model and Serial Number InformationPlate Engine Serial no Important Safe Operation Practices General OperationPage Page Children Slope OperationDo not Service Safety Frame RopsOperating the PTO Page Safety Labels Safety Labels Switches and Dash Mounted Controls Controls and FeaturesIgnition Switch Light Switch Turn Signal SwitchHazard Lamp Switch PTO SwitchHand Throttle Lever Forward/Reverse Shift LeverInstrument Panel Tachometer Hourmeter Clutch Pedal Floor Board and Fender Mounted ControlsBrake Pedals Right and Left Foot Throttle Main Shift LeverHi-Lo Range Shift Lever Auxiliary Hydraulics Lever OptionalHydraulic Control Levers Differential Lock PedalBrake Pedal Lock Seat Adjustment Lever Mid PTO LeverOperation Rollover Protective Structure RopsPRE-STARTING Checks Fueling the TractorNEW Tractor BREAK-IN Procedures Starting the EngineStopping the Engine Driving the TractorStopping the Tractor Driving on Slopes Turning the TractorDriving on Roadways Check While Operating Travel SpeedsUsing the Front Wheel Drive Using the Differential LockUsing the Position Control and Draft Control Levers Using the MID PTO Using the DrawbarGround Penetration w/Draft Control and Position Surface Penetration w/Draft Control OnlyUsing the Three Point Hitch Top LinkLifting Rods Check LinksUsing Remote Hydraulics Optional Tractor WeightingAdjustments Adjusting the SeatAdjusting Front Wheel TOE-IN Adjusting Front AxleClutch Adjustment Adjusting the FAN Belt TensionBrake Adjustment Adjusting Rear Wheel Tread Width Adjusting the Micro Switch HeightTo Adjust Checking Steering Wheel Lubrication Table MaintenanceGeneral Information Lubrication and Maintenance Chart Service Intervals Operation toAccessing the Engine Compartment Fuel System Servicing the Fuel Filter Bleeding the Fuel System Checking the Fuel Lines Checking the Engine Oil Level Engine OIL and OIL FilterAdding Engine Oil Changing Engine Oil and Filter Checking the Transmission Oil Level Transmission OIL and OIL FilterChanging the Transmission Oil and Filter Servicing the Front Axle Checking the Front Axle Oil LeverAdding Front Axle Oil Changing the Front Axle OilServicing the AIR Cleaner Draining the Clutch HousingServicing the Cooling System Checking and Cleaning Radiator ScreenChecking and Adding Coolant Checking the Radiator Hoses Changing the CoolantLubricating the Tractor Brake pedal shaft both sides. See Figure Servicing the Battery General Battery InformationBattery Removal Battery MaintenanceRe-charging the Battery Battery StorageServicing the Electrical System Fuses Fuse BoxTire Maintenance Main Slow Blow FuseTractor Storage Engine Troubleshooting TroubleshootingWhen Engine is Difficult To Start When Output Is Insufficient When Color of Exhaust Is Especially BadWhen Engine Suddenly Stops When the Engine Must Be Stopped ImmediatelyTractor Troubleshooting When Tractor Does Not Move While Engine Is RunningBattery Troubleshooting Condition of Battery Cause CountermeasuresSpecifications ModelPTO CUB Cadet LLC Post Office BOX CLEVELAND, Ohio
Top Page Image Contents