Husky H2000 Problem Or Concern, Possible Cause, Solution, needs. Never use Bleach, Ammonia or

7.0 TROUBLESHOOTING

PROBLEM OR CONCERN	POSSIBLE CAUSE	SOLUTION
Detergent Leak	Disconnected or Kinked Detergent	Remove the front cover of the unit and check if the
	Pick up Tube	clear tube is still properly attached or kinked. If it is
		not attached then reconnect it or unkink it.
Reservoir Tank won’t hold	Chemical Tank Nipple Broken	The Chemical Tank Nipple is attached to the inside
Detergent		wall of the Reservoir Tank. If it is broken you can
		order a replacement by emailing us at:
		customerservice@huskypowerwasher.com.
Detergent is not dispensing	Incorrect wand is attached to the	Make sure that the Click-N-CleanTMwand is
	Gun	attached to the Gun and set in the “Detergent
		Spray” position Detergent will not dispense with
		the Turbo Wand
	The Click-N-CleanTMwand is not set	Turn the shaft of the wand until clicked into the
	in the “Detergent Spray” position.	“Detergent Spray” position (see fig.7 pag. 15).
	Nozzle is clogged with debris	Straighten out a paper clip and insert it into the tip
		of the Nozzle. Back flush the Nozzle with water.
		(see section 5.2)
Detergent to Water ratio		Adjust the Dial-N-Wash®dial to increase/decrease
		detergent flow. Most power washer chemicals are
		generally concentrated within that range so minimal
		adjustment is required. If you feel like you are using
		more detergent than is required for the application you
		can dilute it with regular tap water. (see section 4.3)
Detergent - What to use		We recommend that you use a cleaner which is
		specifically designed for power washers. There
		are different kinds available depending on the
		application. Check with your local Home Depot
		store for the product which is best suited for your
		needs. Never use Bleach, Ammonia or
		Hot water in the unit.
Detergent Tank fills up with	Detergent Suction Assembly (the	The part will have to be replaced, Please email
water	part which the High Pressure hose	us directly at:
	connects to) is defective	customerservice@huskypowerwasher.com.
		You can also order the part directly at:
		www.huskypowerwasher.com.
Circuit breaker trips or Fuse	Circuit overload	Check that the circuit is rated at 15 amps or
blown in Fuse Box		greater. Make sure the unit is plugged into a
		dedicated circuit.
	Extension cord too long or wire	Use proper extension cord as recommended in
	size too small	Owner’s Manual.
	Nozzle partially blocked	Clean Nozzle as instructed in section 5.2.
	Excessive pressure	Clean Nozzle as instructed in section 5.2
GFCI Plug installation		For GFCI reset procedures see owner’s manual section
GFCI Plug malfunction		3.3. For instructions regarding the GFCI Plug installa-
		tion or malfunction please email us directly at:
		customerservice@huskypowerwasher.com.

23