Karcher K 5.50 M Important Precautions, Assembly Instructions, Water Supply Cold Water Only, Step

IMPORTANT PRECAUTIONS – continued

Water Supply (Cold Water Only)

•Water hose must be at least a 1/2 inch or 5/8 inch in diameter.

•Flow rate of water supply must not fall below 2 GPM (gallons per minute).

•Flow rate can be determined by running the water for one minute into an empty 5-gallon container.

•The water supply temperature must not exceed 104°F/40°C.

•Never use the pressure washer to draw in water contaminated with solvents, e.g. paint thinners, gasoline, oil, etc.

NOTE: Dirt in the feed water will damage the unit. To avoid this risk, we recommend fitting a water filter.

•Always prevent debris from being drawn into the unit by using a clean water source and an accessory water filter if required.

ASSEMBLY INSTRUCTIONS

4

Step 1

Assemble the support leg by aligning the two holes to the machine. Tighten each of the two screws provided.

Step 2

Slide the two handle posts into the mobile adaptor and line up the holes. Insert two screws and tighten.

Step 3

Assemble the handle by aligning the holes to the handle posts. Insert two screws and tighten.

Step 4

Pull out the locking slide from the right side of the trigger gun handle. Insert the small end of the high pressure hose into place.

Step 5

Push the locking slide back into the trigger gun to lock the hose in position.