ASSEMBLY
Do not turn the power switch on until the Parts Washer has been completely assembled. Failure to do so could result in serious injury or electric shock.
Unpack product from package and review contents. Keep all packaging until product has been reviewed.
1.Follow the diagram (Figure 1).
2.Place the body (#7) upside down onto a flat
surface.
3Begin by assembling the legs to the shelf (12). When the four legs (13) have been attached, mount them to the body. Be sure to use the appropriate Screws, Washers and Nuts on each leg and on the shelf.
Figure 2 - Opening
4.Place the Parts Washer upright and on the legs.
5.Run the Cord and the On/Off switch through the opening (Figure 2). Slide the assembly down (Figure 3). The assembly should fit securely. (If the On/Off switch is too tight onto the housing and won’t easily move down (Figure 4), loosen the screws slightly.)
6.Place the filter screen into the filter cover. Move the pump housing cover into the slots on the front of the pump housing.
Figure 1
Figure 3
Figure 4
OPERATION
Do not use volatile, flammable or combustible solvents, or fuels such as gasoline, diesel, or toluene. Use only
The pump must be immersed in liquid while operating. Fluid should be replaced and the Parts Washer cleaned on a regular basis to avoid hazardous conditions.
Chlorinated solvents such as
Fill the body with the cleaning solution, to just below the horizontal crease on the body.
Lift the cover, placing the items to be cleaned into the work basket. Then set the work basket into the cleaning solution.
Plug the power cord into a power source. Turn the power switch ON.
When the tool is cleaned, turn the power switch OFF, and unplug from the power source.
PWASH20 20 Gallon Parts Washer Assembly & Operating Instructions | 8 |