How To Use Your Pressure Washer
On the end of your spray gun is a nozzle that you can slide forward and backward and that you can also twist from side to side. With the adjustable nozzle you can adjust the spray pattern to either high pressure
or low pressure. You can also adjust the spray so it is concentrated in a stream pattern or expanded into a fan
pattem.
•Slide the nozzle forward for low pressure. Pull nozzle back for high pressure.
HIGH PRESSURE | LOW PRESSURE |
•To adjust your spray pattern twist the nozzle clockwise for fan spray or counterclockwise for stream spray.
FAN SPRAY | STREAM SPRAY |
•For most effective cleaning, keep spray nozzle between 8 and 24 inches from cleaning surface.
IMPORTANT" If you get spray nozzle too close, especially on high pressure, you may damage the surface you are cleaning.
•The pressure control knob is located on the pump. You can increase the pressure by turning the knob clockwise or decrease the pressure by turning the knob counterclockwise.
PRESSURE
CONTROL
KNOB
NOTE: The maximum pressure for the unit is set at it's maximum setting at the factory. Do not attempt to adjust
the pressure higher than this factory setting.
Using Soaps/Chemicals
IMPORTANT: Use soaps and chemicals that are designed specifically for use with pressure washers. To apply soaps/chemicals follow these steps:
•Prepal;e'thesoap/chemical as required by your job.
•Insert soap/chemical line into your container (soap/ chemicals not included).
C. AL
CHEMICAL
JUG_ _._
NOTE: The first step involves applying an appropriate soap/chemical solution to penetrate and loosen grime.
ADDIV the solution at low pressure to avoid splashing,
over spray and waste. Leave the solution on surface for 3to 5 minutes to allow solution to work.
NOTE: The second step involves cleaning the surface you have prepared with the pressure washer and then rinsing it clean.
•Slide the adjustable nozzle forward to low pressure mode. Soap/chemicals cannot be applied with nozzle in high pressure position.
•Review the use of the adjustable nozzle.
•Connect garden hose to water inlet (see "ToStart Your Pressure Washer"). Check that high pressure hose is connected to spray gun and pump (see Assembly), and start engine.
•Apply soap/chemicals to dry surface, starting from the bottom and working up.
•Allow the soap/chemicals to soak in between
•For cleaning, start at lower portion of area to be washed and work upward, using long, even over- lapping strokes.
•Your pressure washer is equipped with a chemical injector adjustment knob. With the knob fully opened you will get a maximum chemical draw. With knob
fully closed you will get no chemical draw. Turn knob in counter clockwise direction to achieve more chemical draw and clockwise for less chemical draw,
CHEMICAL
INJECTOR
ADJUSTMENT
KNOB
10