Craftsman 919.76235 owner manual Length of Coverage

Page 28

BdggS & Stratton Corporation (B&S), the California Air Resources Board (CARB)

and the United States Environmental Pr,otactfon Agency (U.S. EPA)

Emission Control System Warranty Statement (Owner s Defect Warranty Rights and Obligations)

Inthe interestofthe environment, B&Senginas that meet strictemis- sionrequlremantsarelabeled,"Thisengineconformsto 1995-1998

California emission regulations for ULGE engines and U.S. EPA Phase I regulationsfor small non-road engines."

EMISSION CONTROL WARRANTY COVERAGE IS APPUCABLE California and United State==Emlulon

CARB, U.S. EPA and B&S are pleased to explain the Emission

ControlSystem Warranty on your 1996and later utilityor lawn and garden equipment(ULGE) engine. In Calitomia,new ULGE engines produced on or after August t, 1995 must be designed, built and

equipped to meet the State'sstringentanti-smog standards,Else- where in the United States, new non-road,spark-ige_ engines

certifiedfor modelyear 1997 and later, must meet similarstandards set forth by the U.S. EPA. B&S must warrant the emissioncontrol

TO CERTIFIED ENGINES PURCHASED IN CALIFORNIA IN 1995 AND THEREAFTER, WHICH ARE USED IN CALIFORNIA, AND TO CERTIFIED MODEL YEAR 1997 AND LATER ENGINES

WHICH. ARE PURCHASED AND USED ELSEWHERE IN THE UNITED STATES.

Control Defects Warranty Statement

there has been no sbuse, neglect or impropermaintenance of your

ULGE engine.

Youremissioncontrolsystem includesparts suchas the carburetor, air cleaner, ignition system, muffler and catalytic conveder. Also includedmay beconnastorsand other emissionrelatedassemblies. Where a warrantable condition exists, B&S will repair your ULGE engine at no cost to you includingdiagnosis, parts and labor.

systemon your engine for the periods of time listedbelow,provided

Brfggs & Stratton Emission Control Defects Warranty Coverage

ULGE engines are warranted relative to emission control pads

below, lfanycoveredpadonyourangineisdetective, thepadwi, be

detects for a period of two years_ subject to provisionsset forth

repaired or replaced by B&S.

Owner'sWarranty Responsibilities

As the ULGE engine owner,you are responsiblefor the performance of the requiredmaintenance ]istsd in yourOperator/Owner Manual. B&S recommendsthat you retain all yourreceiptscovering mainte- nance on your ULGE engine, but B&S cannot deny warrantysolely for the lack ofreceiptsorfor yourfailure toensurethe performanceof all scheduledmaintenance.

Asthe ULGE engine owner,youshouldhoweverbe aware that B&S may deny you warranty coverage if your ULGE engine or a part has failed due to abuse, neglect, impropermaintenance or unapprovod modifications.

You are responsiblefor presentingyour ULGE engine to an Autho- dzed B&S Service Dealer as soon as a problem exists. The undis-

putedwarrantyrepairs should be completed ina reasonebla amount of time, not to exceed 30 days.

If you have any quastlons regarding your warranty rights and responsibilities, you shouldcontacta B&S Service Representative at 1-4! 4-259-5262.

The emissionwarranty isa defects warranty.Defects are judged on normal engine performance. The warrantyis not related to an in-use emission test.

Brlggs & Stratton Emission Control Defects Warranty Provisions

The following are specificprovisionsrelativetoyour EmissionControlDefects Warranty Coverage. It is in additiontothe B&S engine warranty

for non-ragulatedengines found in the Operator/Owner Manual.

1.Warranted Parts

Coverage under this warranty extends only to the parts listed below (the emission control systems parts) to the extent these parts were present on the engine purchassd.

a. Fuel Metering System

Cold start enrichment system (serf choke)

Carburetor and internal pads

,, Fuel Pump

b.Air Induction System

• Air cleaner

. Intake manifold

c.Ignition System

Spark piog(s)

Magneto ignition system

d.Catalyst System

Catalytic converter

Exhaust manifold

Air injection system or pulse valve

e. Miscellaneous Items Used in Above Systems

Vacuum, temperature, position,time sensitivevalves and switches

Connectors and assemblies

2.Length of Coverage

B&S warrantstothe initia_ownerand each subsequentpurchaser that the Warranted Parts shall be free from defects in materials and workmanship which caused the failure of the Warranted Parts for a penod of two years from the date the engine is deliv- ered to a retail pumhaser.

3.No Charge

Repair or replacementof any Warranted Part will be performed at no charge to the owner, including diagnostic labor whichleads to the determination that a Warranted Part is defective, if the

diagnostic work is performed at an Authorized B&S Service Dealer. For emissions warranty service contact your nearest Authorized B&S Service Dealer as listed in the "Yellow Pages" under "Engines, Gasoline," "Gasoline Engines," "Lawn Mowers," or similarcategory.

4.Claims and Coverage Exclusions

Warranty claims shall be tiled in accordance with the provisions of the B&S Engine Warranty Policy. Warranty coverage shall be excluded for failures of Warranted Parts which are not original B&S parts or because of abuse, neglect or improper mainte- nance as set forth in the B&S Engine Warranty Policy. B&S is net liable to cover failures of Warranted Parts caused by the use of add-an, non-or'_ginsi,ormodified parts.

5.Maintenance

Any Warranted Part which is not scheduledfor replacement as required maintenance or which is scheduled only for regular

inspectionto the effectof =repair or replace as necessary" shall be warranted as to defects for the warranty period. Any Warranted Partwhich is scheduledfor replacement as required maintenance shallbe warrantedas to defects onlyfor the period of time up to the first scheduled replacement for that part. Any replacementpart thatis equivalentinperformance and durability may be used in the performanceof any maintenance or repairs. The owner is responsible for the performance of all required maintenance, as defined in the B&S Oparator/Owner Manual.

6.ConsequentialCoverage

Coverage hereunder shall extend to the failure of any engine componentscaused by the failure of any Warranted Part still under warranty.

28

Image 28
Contents IRItFTSMnN Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.ATable of Contents HOW to Prevent IT Hazard Risk of Explosion Or FireWhat can Happen Breathing exhaust fumes will cause serious injury or deathHazard Never point wand at, or spray people or animalsCarton Contents OwnersManual Nozzle Cleaning Kit and Replacement O-RingsHazard Risk of HOT Surfaces What can Happen Bag ContainingTools Required for Assembly Adjustablewrench GAS HoseChoke Not smoke or have open flame when tilting fuel Before Starting the EngineTo operate the engine you will need to do Gasoline Your pressure washer engine is 4 cycle. Use freshTo Start Your Pressure Washer RUN positionHigh Pressure LOW Pressure How To Use Your Pressure WasherFAN Spray Stream Spray Task RPMAIR Cleaner Service Air Cleaner Pre-CleanerCarburetor Multi-Reg Wand/LancePreparing Pressure Washer for Storage Engine Preparation Solution SymptomCause Craftsman 2350 PSi High Pressure Washer REF NO. Part noDescription REF NO. Part NO. DescriptionPage PER Part Description QTY =KIT307 11si 525 116A 987 108 127 130A 534 l Part 3os Part Description 689 373855 51 9560Length of Coverage Briggs&Strattonwelcomeswarrantyrepairandapologizes Strattongasoline stabilizer,Part NoPage Page Part Crafisman Garanta Limitada DE UN AiO Para Lavadoras Craftsman DE Alta PresionGaranta Limitada DE UN Aiio DEL Motor Craftsman Sears, Roebuck and Co,, D/817 WA, Hoffman Estates, ILRiesgo QuepuedesucederComo Prevenirlo Riesgo DE INYEC¢ION DE LquidoLeere.jitl Manual IL/Prende r DetenerCduetlble Operad6n Riesgo QUE Puede Suceder Como PrevenirloImportante Herramlentas Requeridas part= el Ensamblaje Preparaci6n de la Lavadora de Presi6n pare el Primer UsoChoke Palanquita de cebado para arrancar la unidad Interruptor ParaHacer 1osiguiente para hacer que el motor funcione Apagado de la Lavadora de Presi6nAceite del Motor Mds fifo i-----4C/40F Mas caliente Sinttico 5W-30 SAESeguro Como user la Lavadora de Presi6n PRESl6N Alta PRESl6N BajaChorro EN Abanico Chorro Concentrado Luego enjuagadaResponsabilidades DEL Propietario En agua y sifonear agua por 1 a 2 minutosRecomendaciones Generales Especificaciones del Equipo Seguir estos pasos para eliminar ef aire de la bomba Filtro de Aire de Doble Elemento CarburadorLimpiar y Reemplazar la Buja Limpieza de la BoquillaAntes de almacenar la unidad por 30 dfas o ms. Nunca Preparaci6n Del Motor De ia BombaCausa SntomaSOLUCI6N VEA LA Pagina Version EN Ingles 052 Para Liste DE Partes VEA LA Pagina Version EN Ingles Para Liste DE VEA LA Pagina Version EN Ingles Page Page Sears

919.76235 specifications

The Craftsman 919.76235 is a high-performance air compressor designed for both professional and DIY enthusiasts. This versatile machine stands out in the market due to its robust build quality, efficient operation, and user-friendly design.

One of the main features of the Craftsman 919.76235 is its powerful motor. With a horsepower rating that drives a reliable pump, this air compressor is capable of delivering a consistent airflow that can handle a wide range of tasks, from inflating tires to powering pneumatic tools. The compressor has a substantial tank capacity, which allows for extended usage without frequent refilling, a significant advantage for those who require continuous air supply for their projects.

This air compressor operates at a maximum pressure of 135 PSI, which is suitable for most home and professional applications. The quick recovery time ensures that the compressor is back up to pressure shortly after pressure drops, allowing for uninterrupted work. The compressor also features a gauge that provides real-time feedback on the air pressure, enabling users to monitor their operations effectively.

Another standout characteristic is its portability. The Craftsman 919.76235 is designed with built-in wheels and a handle, making it easy to transport from one job site to another. This feature is particularly beneficial for contractors who work in various locations or for users who may need to move the unit around their workshop.

In terms of safety and maintenance, the Craftsman 919.76235 incorporates several thoughtful features. An automatic shut-off function prevents the compressor from over-pressurizing, which can lead to potential hazards. Additionally, the oil-free pump design means that users do not need to worry about regular oil changes, significantly reducing maintenance requirements and enhancing the machine's overall reliability.

The Craftsman 919.76235 is compatible with a variety of air tools, making it an excellent investment for both home use and professional applications. Whether it involves painting, nailing, or using impact wrenches, this air compressor meets diverse needs with ease.

In conclusion, the Craftsman 919.76235 air compressor delivers an impressive array of features, including a powerful motor, high maximum pressure, portability, and user-friendly operation. Its design prioritizes both efficiency and safety, making it an ideal choice for those seeking a dependable and versatile air compressor for various tasks.