Craftsman 580.76201 owner manual Read this manual and follow all Safety, Maintenance and Storage

CAUTION: ALWAYS DISCONNECT SPARK PLUG WIRE AND PLACE WIRE WHERE IT CAN+ NOT CONTACT SPARK PLUG, TO PREVENT ACCIDENTAL STARTING WHEN SEI-rlNG UP,

TRANSPORTING, ADJUSTING OR MAKING REPAIRS TO YOUR HIGH PRESSURE WASHER.

Never move the machine by pulring on the high pressure hose. Use the handle provided on the top of the unit.

read this manual and follow all Safety

---] CAUTION: Before using this product, Rules and Operating Instructions.

Engineexhaust gases containDEADLY carbon monoxide gas. This dangerous gas, if breathed in sufficient concen- trations, can cause unconsciousnessor even death.

Operate this equipment only in the open air where ade- quate ventilation is available.

Gasoline is highly FLAMMABLE and its vapors are EXPLOSIVE. Do not permit smoking, open flames, sparks or heat in the vicinity while handlinggasoline. Avoid spilling gasoline on a hot engine. Allow unit to cool for 2 minutes before refueling. Complywith all laws regulaflng storage and handling of gasoline.

The muffler and engine will heat up during operation and remain hot immediately aftershutting it down. Avoid any contact with a hot muffler or engine or you could be severely burned.

The high pressure equipment is designed to be used with Sears authorized partsonly. If you use this equipment with

parts that do not comply with minimum specifications, the user assumes all risks and liabilities.

Operate engine only at governed speed. Running engine at excessive speeds increasesthe hazard of personal injury. Do not tamper with parts which may increase or decrease the governed speed.

Before starting the Pressure Washerin cold weather, check all parts of the equipment and be sure ice has not formed there.

The muffler and air cleanermust be installed and in good condition before operating the Pressure Washer. These components act as spark arrestors if the engine backfires. Check fuel system for leaksor signs of daterioration such as chafed or spongy hose, looseor missing clamps or damaged tank or cap. Correct all defects before operating the Pressure Washer.

Units with broken or missing parts, or without protective housing or covers should NEVER be operated.

Do not adjust unloader valve to a pressurein excess of machine raflng.

Operate the pressure at no more than the PSI fluid pressure rated for your pressure washer.

High pressure spray can cause paint chips or other particles to become airborne and fly at high speeds.

High pressure spray may damage fragile items including glass. Do not point spray gun at glass when in the jet spray mode.

Keep the hose connected to machine or the spray gun while the system is pressurized. Disconnecting the hose while the unit is pressurized is dangerous.

Always be certain the spray gun, nozzles and accessories are correctly attached.

Hold the spray gun firmly in your hand before you start the unit. Failure to do so could result in an injury from a whip- ping spray gun. Do not leave the spray gun unattended while the machine is running.

Never use a spray gun which does not have a trigger lock or trigger guard in place and in working order.

Do not secure trigger gun in the puU-back(open) posiUon.

Keep water spray away from electdc wiring or fatal electdc shock may resutt.

The cleaning area should have adequate slopes and

drainage to reduce the posaibiiity of a fall due to slippery surfaces.

Locate this pressure washer in areas away from any combustiblematerials, combustiblefumes or dust. Do not spray flammable liquids.

Some chemic_s or detergentsmay be harmful if inhaled or ingested, causing severe nausea, fainting or poisoning. These harmful elements may also cause propertydamage or severe injury.

Use a respiratoror mask whenever there is a chance that vapors may be inhaled. Read all instructionswith the mask so you are certainthe mask will providethe necessary pro- tecflon against inhaling harmfulvapors.

AJwayswear eye pmtectk_ when you use this equipmentor when youare in the vicin_.ywhere the equipmentis in use. Do not wear loose clothing,jewelry or anythingthat may be caught in the starter or other rotatingparts.

Do not allow CHILDREN to operate the PressureWasher at any time.

Never aim the gun at people, animals or plants.

This equipment produces high pressurestreams of fluid which can pierce the skin and itsunderlying tissues,

leading to sehous injury and possible amputation.

Never allow any part of the body to come in contact with the fluid stream. DO NOT come in contact with a fluid

stream created by a leak in the high pressure hose.

Do not by-pass any safety device on this machine.

MAINTENANCE AND STORAGE:

Operate and storethis unit on a stable surface.

High pressure hose can develop leaks from wear, kinking, abuse, etc. Water spraying from a leak is capable of inject- ing material into skin. Inspect hoseeach Umebefore using it. Check all hoses for cuts, leaks, abrasions or bulging of cover,or damage or movement of couplings,if any of these conditionsexist, replace hose immediately. Never repair high pressure hose. Replace it with anotherhose

that meets minimum pressure rating of your pressure washer.

AIT MEANS "A'I-I'ENTION!!!BECOME ALERT!!! YOUR SAFETY IS INVOLVED."

LOOK FOR THIS SYMBOL TO POINT OUT IMPORTANT SAFETY PRECAUTIONS. I

3