4.4Start and stop of the machine (when con- nected to a water supply)
The spray lance is affected by a thrust during operation - therefore always hold it fi rmly with both hands. IMPORTANT:
Point the nozzle at the ground.
1.Check that the machine is in upright position.
NOTE: Do not place the machine in high grass!
2.Release the trigger lock.
3.Activate the trigger of the spray gun and let the water run until all air has escaped from the water hose.
4.Turn the start/stop switch (1) to position"I".
5.Activate the trigger of the spray gun.
Always adjust the distance and thus the pressure of the nozzle to the surface, which is to be cleaned.
Do not cover the machine during operation.
Note: If the ma- chine is left or not used for 5 min-
utes, it must be switched off on the start/stop switch "O" (1):
1.Turn the start/stop switch (1) to position"O".
2.Disconnect the electrical plug from the socket.
3.Shut off the water supply and activate the trigger to relieve the machine of pressure.
4.Lock the spray gun.
When releasing the trigger of the spray gun, the machine automatically stops. The ma- chine will start again when you
4.5Start the machine (when connected to open con- tainers (suction mode))
The washer can take in water from a rain water tank as an example. The hose for the wa- ter supply must not be too long, approx. 5 m.
Make sure that the water tank is not placed on a lower level than the machine.
1.Place the other end of the water hose in the water tank. Use an external fi lter if the water contains impurities.
2.Turn the start/stop switch (1) to position"I".
3.Activate the trigger of the spray gun and let the water run, until the air has escaped from the water hose and the pump.
4.Mount spray lance and nozzle.
4.6Pressure regulation on the TORNADO® PR- nozzle
High pressure |
Højtryk |
Lavtryk |
Low pressure |
The pressure can be regulated on the TORNADO® PR nozzle.
8