Nilfisk-ALTO 106269015 manual Buildings and Equipment Task Accessories Method

NEPTUNE PE

5.2.3 Buildings and Equipment

Task	Accessories	Method
General surfaces	Foam injectors Stand-	1. Apply thick foam over the surfaces to be cleaned.
	ard lance	Apply on dry surfaces. Apply from top to bottom on
Metallic equipment	Curved lances
		vertical surfaces. Let the foam act for up to 30 min-
	Tank cleaning
		utes for the optimal effect.
	head
		2. Proceed with cleaning using the high pressure
	Detergents	lance. Use applicable accessories. Use high pres-
		sure to dislodge large amounts of incrusted dirt or
	Intensive
		grime. Use lower pressure and high water volume in
	J25 Multi
		order to rapidly flush away loose dirt and rinse sur-
	Combi Active
		faces.
	Alkafoam
		3. Apply DES 3000 disinfectant once the surfaces are
	Disinfectant	perfectly clean.
	DES 3000	Areas covered by amounts of loose dirt, such as ani-
		mal remains in slaughterhouses, can be removed by
		using high water flow to fl ush away the dirt to evacua-
		tion pits or drains.
		Tank cleaning heads can be used to clean barrels,
		vats, mixing tanks etc. Cleaning heads may be hydrau-
		lically or electrically powered and give the possibility for
		automatic cleaning without a constant user.
Rusted or dam-	Wet Sandblasting	1. Connect the sandblasting lance to the pressure
ages surfaces prior	equipment
to treatment		washer and place the suction tube in the sand.
		2. Always wear protective equipment during sandblast-
		ing.
		3. Spray the surfaces to be treated with the mix of wa-
		ter and sand. Rust, paint etc will be stripped off.

These are merely several examples of cleaning tasks that can be solved by a pressure washer in asso- ciation with accessories and detergents. Each cleaning task is different. Please consult your local dealer or Nilfisk-ALTO representative in order to discuss the best solution for your own cleaning tasks.

11