Nilfisk-ALTO 106269015 manual After using the cleaner, Switching off Cleaner, Storing / frost

NEPTUNE PE

6 After using the cleaner

6.1Switching off the

cleaner

1.Close water tap

2.Activate spray handle without lance in order to empty all residual water in the system.

3.Turn the ON/OFF switch to position “OFF”.

4.Turn off the engine.

5.Activate spray handle until the washer is depressurised.

6.Lock the safety catch on the spray handle.

6.2 Storing / frost	It is advisable to store the ma-
protection	chine in a frost proof place be-
	tween operations. If this is not
	possible the machine should be
	protected in the following way:
	1. Disconnect the water inlet
	hose. Remove the lance and
	empty it of water.
	2. Start the machine allowing it
	to run with the spray handle
	opened until it is empty of
	water.
	3. Place a suction hose in a
	bucket with 6-8 l (1.5-2 gal-
	lons) anti-freeze.
	4. Place the spray handle (with-
	out spray lance) above the
	bucket, activate the spray
	handle so that the anti-freeze
	can circulate.

5.Place the psray handle above the opening of the anti-freeze container and allow the ma- chine to pump all of the solu- tion back into the anti-freeze container. The anti-freeze can be re-used, but keep in mind that it is slightly diluted with water each time this is done.

Important:

To avoid damage always ensure that the washer, the hoses and the spray lance are unfrozen before restarting. Place the washer and the accessories in a warm environment for some time before starting up.

12