OPERATING PROCEDURES (cont'd)
Pressure adjustment: | Annovi Reverberi |
The pressure setting is preset at the factory to achieve optimum pressure and cleaning. If you need to lower the pressure, it can be accomplished by two methods.
The first method is to back away from the surface to be cleaned. The further away you are, the less the pressure will be on the surface to be cleaned.
The second method is to adjust the pressure regulator on the pump. Please read the following instructions for adjusting the pressure regulator:
Refer to page 16 and 17 to identify the pump that is on your pressure washer. The pressure is not adjust- able on DAPC, Faip, Karcher, or smaller Giant pumps.
The Annovi Reverberi, Cat, General and larger Giant pumps pressure can be lowered by turning the pressure regulator counterclockwise. Refer to the illustrations to the right to identify your pressure regulator.
Once you have finished using your pressure washer, return the pressure regulator to its original position by turning it clockwise.
DO NOT attempt to increase pump pres- sure. A higher pressure setting than the factory set pressure will damage pump.
CAT
General
Giant (beltdriven) P316
Giant P303
(unloader mounted on frame)
Giant (beltdriven) P316
(unloader mounted on pump)
14 — ENG