DeVillbiss Air Power Company D21684 warranty Operating Procedures contd High Pressure Operation

Page 11

OPERATING PROCEDURES (cont'd)

High Pressure Operation:

DO NOT let hoses come in contact with very hot engine muffler during or immedi- ately after use of your pressure washer.

RISK OF INJECTION OR INJURY TO PERSON. DO NOT DIRECT DISCHARGE STREAM TOWARD PERSONS.

WHEN USING THE HIGH PRESSURE SETTING, DO NOT ALLOW THE JET-LIKE SPRAY TO COME IN CONTACT WITH UNPROTECTED SKIN, EYES, OR WITH ANY PETS OR ANIMALS. SERIOUS INJURY CAN OCCUR.

Multi-RegPull back nozzle for high pressure— Figure 7.

Hi-LowTurn knob clockwise until it stops—Figure 8.

Dual Lance — Turn black handle grip clockwise until it stops—Figure 9.

NOTE: O°, 15°, 25°, and 40° nozzles will change the fan spray. The size of the nozzle will determine the size of the fan spray. To change nozzles:

1.Shut off the pressure washer and turn off the water supply.

2.Pull trigger on gun handle to relieve any water pressure.

3.Remove the nozzle on the end of the wand.

4.Insert new nozzle and tighten securely. Note: Be sure to teflon tape nozzle prior to assembly. Maintain at least one thread away from the end when applying the tape. You must wrap teflon tape in the direction of the threads. Two wraps only required.

Multi-Reg (High Pressure Setting)

Figure 7

Hi-Low

Figure 8

Dual Lance

Figure 9

11 — ENG

Image 11
Contents Pressure Washer Service Policy Index Frequently Asked Questions Important Safety Instructions Safety Glossary Manual for Safety, Operation, and Maintenance InstructionsCleaning Units GPM x PSI Owners ResponsibilitiesAssembly BOX ContentsIllustration a Illustration B Multi-Reg Hi-Low/Quick Connect Dual LanceIllustration C Operating ProceduresStart-Up Connect Water Turn on Water Operating Procedures contdMulti-Reg High Pressure Setting Hi-Low Dual Lance Operating Procedures contd High Pressure OperationQuick Connect with Nozzles Quick Connect Coupler Illustration a Operating Procedures contd Low Pressure OperationMulti-Reg Low Pressure Setting Annovi Reverberi Operating Procedures contd Pressure adjustmentTurn off Water Operating Procedures contd Chemical Flow AdjustmentShut Down Procedure Thermal Relief ValveHours MaintenanceWith 10W30 synthetic oil Maintenance contdFollowing pump 2200 psi Following pump 2400 psi Was shipped from the factoryDual Lance Soap Nozzle Maintenance contd Nozzle cleaningMaintenance contd Water Inlet Screen Cleaning Preparation for Storage Storage & Winter StorageProblem Cause Correction Troubleshooting GuideIf equipped with Idle down AssemblyIdle down assembly if Engine will not idle downLimited Warranty General Manual for