Briggs & Stratton 020219 owner manual Assembly, Preparing Pressure Washer for USE, Carton Contents

2450 PSI Pressure Washer

ASSEMBLY

IMPORTANT: Read entire owner’s manual before you attempt to assemble or operate your new pressure washer.

Remove Pressure Washer From Carton

1.Remove parts bag packed with pressure washer.

2.Slice two corners at end of carton from top to bottom so panel can be folded down flat, then remove all packing material.

3.Roll pressure washer out of carton.

Carton Contents

Items in the carton include:

•Main Unit

•Safety Goggles

•Handle

•High Pressure Hose

•Spray Gun

•Adjustable Nozzle Extension

•Oil Bottle

•Parts Bag (which includes the following):

•Owner’s Manual

•Engine Manual

•Maintenance Kit

•Handle Fastening Hardware Kit (which includes):

•Carriage Bolts (2)

•“L” Hooks (2)

•Plastic Knobs (4)

PREPARING PRESSURE WASHER FOR USE

If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the pressure washer helpline at 1-800-743-4115.

To prepare your pressure washer for operation, you will need to perform these tasks:

1.Attach handle to main unit.

2.Add oil to engine crankcase.

3.Add fuel to fuel tank.

4.Connect high pressure hose to spray gun and pump.

5.Connect water supply to pump.

6.Attach nozzle extension to spray gun.

Attach Handle to Unit

1.Place handle assembly onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 1).

Figure 1 — Attach Handle to Base

Handle

Align Holes

Handle

Supports

NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.

2.Insert carriage bolts through holes from outside of the unit and attach a plastic knob from inside of unit (Figure 2).Tighten by hand.

Figure 2 — Secure Handle

3.Insert one “L” hook through hole just under billboard on right side of handle (viewing from front of unit). Hold hook in place and attach plastic knob from inside of unit (Figure 3).Tighten by hand.

Figure 3 — Attach “L” Hooks to Handle

Spray Gun Hook

Hose Hook

4.Insert other “L” hook through hole just above billboard on left side of handle (viewing from front of unit). Hold hook in place and attach plastic knob from inside of unit (Figure 3).Tighten by hand.

6