Water Temperature Setting

IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING.

!DANGER!

Safety and energy conservation are factors to be considered when selecting the water temperature setting of water heater’s thermostat. Water temperatures above 125°F can cause severe burns or death from scalding. Be sure to read and follow the warnings outlined on the label pictured below.

!D A N G E R

HOT

BURN

Water temperature over 125° F can cause severe burns instantly or death from scalds.

Children, disabled and elderly are at highest risk of being scalded.

See instruction manual before setting temperature at water heater.

Feel water before bathing or showering.

Time/Temperature Relationship in Scalds

Temperature	Time To Produce a Serious Burn
120°F	More than 5 minutes
125°F	1½ to 2 minutes
130°F	About 30 seconds
135°F	About 10 seconds
140°F	Less than 5 seconds
145°F	Less than 3 seconds
150°F	About 1½ seconds
155°F	About 1 second

Table courtesy of Shriners Burn Institute

The chart shown above may be used as a guide

in determining the proper water temperature for your home.

!DANGER: Households with small children, disabled,

or elderly persons may require a 120°F or lower thermostat setting to prevent contact with “HOT” water.

NOTICE: Mixing valves should be installed to reduce the point of use water temperature by mixing hot and cold water in branch water lines. Contact a licensed installer or the local plumbing authority for further information.

The temperature of the water in the water heater can be reg- ulated by setting the temperature dial of the adjustable sur- face mounted thermostat located behind the left tank end cover.

Temperature limiting valves are available, see manual.

!DANGER: Burns from Hot Water and

Steam - Use extreme care when opening relief valves, charging closed loop, and filling storage tank.

The electrical element booster thermostat has been factory set at 122°F (50°C) to reduce the risk of scald injury. Adjusting the thermostat to a higher setting is not recommended. Hotter water increases the potential for Hot Water Scalds.

1	L 10MAY		2002		3	L
		EWT1L2S-203
		RO BERTSHAW
2	L				4	L
		EC O	:	83
		DIFF	:	8
1	T
		65		7
		0		7
		0		0
		6
	5	5			75
					75
					8
	0				8
	0				0
	5

240Va c 30A C S6209N

This thermostat controls the water heater’s heating element only. (A separate thermostat should be uti- lized in monitoring the tempera- ture from the collector).

To comply with safety regulations the thermostat is factory set at 120° F or less where local codes require.

Thermostat

Dial Pointer

!DANGER: Hotter water increases the potential for Hot Water SCALDS.

RS47-21BP, RS80-42BP specifications

The Rheem RS47-21BP and RS80-42BP are innovative water heater solutions designed to meet the diverse needs of modern households. These models incorporate advanced technologies to enhance efficiency, performance, and user convenience.

The Rheem RS47-21BP is a 47-gallon heat pump water heater that provides a strong balance between performance and energy savings. One of its standout features is its impressive energy efficiency rating. This model utilizes heat pump technology harnessing ambient heat from the air to heat water, drastically reducing energy consumption compared to traditional electric water heaters. This results in lower utility bills and a smaller carbon footprint, making it an environmentally conscious choice.

On the other hand, the RS80-42BP is a larger 80-gallon heat pump water heater suitable for families with higher hot water demands. It offers a similar energy-efficient operation as the RS47-21BP but with an increased capacity. This model is perfect for households that require a reliable supply of hot water for multiple simultaneous uses, such as showers, dishwashing, and laundry. The unit's size is designed to cater efficiently to larger families or higher demand scenarios, making it an ideal choice for busy homes.

Both models are equipped with advanced smart technology, allowing the user to monitor and control the water heater remotely through a smartphone application. This feature provides real-time data on water usage and energy consumption, empowering users to manage their hot water needs proactively. Furthermore, the intuitive interface makes it easy to adjust settings, helping households maximize efficiency.

Additionally, Rheem has incorporated protective features in both models, including an intelligent self-diagnostic system that assists in troubleshooting. The LED display offers clear indications of operational status, making maintenance straightforward. Both units come with durable construction, designed to resist corrosion and prolong their lifespan.

Overall, the Rheem RS47-21BP and RS80-42BP represent the forefront of water heating technology, combining efficiency, smart technology integration, and ample capacity. These water heaters are not only reliable but also contribute significantly to energy savings, catering to both small and large household needs effectively.