Zenoah BCZ2500SW, BCZ2500SU manual  13 

6. Set up (BCZ2500S, BCZ2500SU)
SE1	■ MOUNTING ENGINE (SE1)
	1.	Push the driveshaft housing toward the clutch
		housing and rotate it by hand to check that the
		driveshaft is engaged with the gears.
	2.	Insert the driveshaft housing into the clutch
		housing until it bottoms, and align the positioning
		holes on the clutch housing and the shaft tube
		and install the screw. When difficult to engage,
		twist the engine slightly.
	3.	Fasten the clamp securely with two screws.
SE2

IMPORTANT

Tighten the screws gradually by turns.

■CONNECTING THROTTLE WIRE

1. Remove the air cleaner cover.

2. Connect the end of the throttle wire to the joint on the top of the carburetor. (SE2)

SE3

(1)

SE4

(1)

(2)

(3)

■CONNECTING SWITCH WIRES

•Connect the switch wires between the engine and the main unit. Pair the wires of the same color.

■INSTALLING HANDLE

•Mount the handle to the shaft tube and clamp it at a location that is comfortable to you. (SE3)

(1) About 19 inches (48cm)

■INSTALLING DEBRIS GUARD

•Put the debris guard on the gear box, attach it with the 4 screws and hardware provided. (SE4)

(1)debris guard

(2)plate

(3)screw

13 