Zenoah EXZ2600DL, EXZ2500S-BC manual MA4,  36 , Muffler, Spark Arrester, Intake AIR Cooling Vent

Page 36

9. Maintenance

MA4

(1)

36

MUFFLER

WARNING

Inspect periodically, the muffler for loose fasteners, any damage or corrosion. If any sign of exhaust leakage is found, stop using the machine and have it repaired immediately.

Note that failing to do so may result in the engine catching on fire.

SPARK ARRESTER

The muffler is equipped with a spark arrester to prevent red hot carbon from flying out of the exhaust outlet. Periodically inspect and clean as necessary with a wire brush. In the State of California it is required by law (Section 4442 of the California Public Resources Code) to equip a spark arrester when a gas powered tool is used in any forest covered, brush covered, or grass covered unimproved land. (MA4)

(1) spark arrester

INTAKE AIR COOLING VENT

WARNING

Never touch the cylinder, muffler, or spark plugs with your bare hands immediately after stopping the engine. The engine can become very hot when in operation, and doing so could result in severe burns.

When checking the machine to make sure that it is okay before using it, check the area around the muffler and remove any wood chips or leaves which have attached themselves to the brushcutter. Failing to do so could cause the muffler to become overheated, and that this in turn could cause the engine to catch on fire. Always make sure that the muffler is clean and free of wood chips, leaves, and other waste before use.

Check the intake air cooling vent and the area around the cylinder cooling fins after every 25 hours of use for blockage, and remove any waste which has attached itself to the

Image 36
Contents OWNER/OPERATOR Manual 848-BP6-93A1Safety First ContentsParts location  3 Specifications  4  5  Symbols on the machine  6 For safe operation Working ConditionWorking Circumstance  7 Working Plan  8 Before Starting the Engine Starting the Engine 9  Using the Product  10 Maintenance If Someone ComesHandling Fuel  11 Transportation  12 Set up  13 EX-BC SE1 SE2 Installing Debris Guard Installing Cutting Head SE2Debris guard Plate Screw EX-BC SE3 Balance UnitEX-LRT SE1 Attaching the Trimming Mechanism SE1 Main pipe Trimming mechanism Screw hole Fastening bolt 15  EX-PS SE1 Attaching the Pruning Mechanism SE1 EX-PS SE2EX-PS SE3  16 Chain tension adjusting screw Loosen Tighten EX-PS SE4 EX-PS SE5 EX-PS SE6Hole Moving direction Chain tensioner nut  17 EX-HE SE1 EX-HE SE2 EX-HE SE3 EX-HE SE4 Clamp bolt Lock screwBracket  18 HOW to MIX Fuel FuelRecommended Mixing Ratio Gasoline 50OIL  19 Fueling the Unit For Your Engine LIFE, Avoid 20  Operation  21 OP6 OP7 OP8 Stopping Engine OP6 22  Adjusting Throttle Cable Adjusting Idling Speed OP10OP9  23 Operation EX-BC only  24  25  EX-BC OP4 EX-BC OP5 EX-BC OP6 Bracket HandleCutting Method  26 EX-BC OP7 EX-BC OP8 Operation Controlling Blade BounceWhat causes kick out  27 How you can reduce the chance of kick out How you can maintain the best control 28  EX-BC OP9 Maintenance Blade Transporting the Unit 29  Adjusting the Angle of the Cutting Blades OP1 Operation EX-LRT onlyEX-LRT OP1 Clamp lever Trimming mechanismAdjusting OIL Flow Rate Operation EX-PS onlyEX-PS OP1 EX-PS OP2 Checking OIL Supply  31  32  Operation EX-HE only EX-HE OP1 33  Maintenance Maintenance Chart 34   35  MA4  36 Muffler Spark ArresterProcedures to be Performed After Every 100 Hours of USE MA51MA6 Cylinder Intake air cooling vent backMaintenance EX-BC only For safety reasons, do not use metalreinforced lineGear Case MA5  38 EX-LRT MA1 EX-LRT MA2 Blades MA1 Upper blade Lower bladeQuick TIP Gear CaseMaintenance EX-PS only EX-PS MA1 MA2 MA3 Oiling PortGuide BAR  40 EX-PS MA4 MA5 MA6 SprocketSAW Chain EX-PS MA7 MA8 MA9  42 Maintenance EX-HE only MA1 Gear Case 43  Troubleshooting guide StorageCheck Probable Causes Action  44 Parts list EX-LRT ATT EX-PS ATT EX-HE ATTEXZ-PU S/N 302845 and up  46  47  EX-BC S/N 302960 and up  48  49  Engine Unit 50100000 and up  50  51  Description Part Number QtyEX-LRT S/N 000531 and up  52  53  Casing BEX-PS S/N 000000 and up  54  55  EX-HE S/N 000101 and up  56  57  Limited Warranty RedMax Garantie limitée Komatsu Zenoah America INC