7. Operation
OP1
OP2
OP3
OP4
OP5
■FUELING THE UNIT (OP1)
1.Remove the fuel tank cap and pour fuel into the tank up to 80% of full capacity.
2.Fasten the fuel cap securely and wipe up any fuel spillage around the unit.
3.Remove the oil tank cap and pour chain oil into the tank. Fasten the cap securely.
WARNING
1.Select bare ground for fueling.
2.Move at least 10 feet (3 meters) away from the fueling point before starting the engine.
3.Stop the engine before refueling the unit.
■STARTING ENGINE
WARNING
Keep clear of the saw chain as it will start rotating upon starting of the engine.
1.Continuously push the priming bulb until fuel comes in the bulb. (OP2)
2.Put the ignition switch to “ I ” position. (OP2)
3.While holding the throttle lever together with the throttle interlock, push in the side button and release the throttle lever to hold it at the start position. (OP3)
4.Pull out the choke knob to the closed position. (OP4)
NOTE
When restarting immediately after stopping the engine, Ieave the choke knob at the open position.
5.While holding the saw unit securely on the ground, pull the starter rope vigorously. (OP5)
WARNING
Do not start the engine while hanging the chain saw with a hand. The saw chain may touch your body. It's very dangerous.
6.When engine has ignited first, push in the choke knob and pull the rope again to start the engine.
7.Allow the engine to warm up with the throttle lever pulled slightly.
11