9. Maintenance
MA5
MA6
MA7
MA8
18
GUIDE BAR
1.Remove sawdust in the bar groove and the oiling port. (MA5)
2.Grease the nose sprocket from the feeding port on the tip of the guide bar. (MA6)
3.Periodically turn over the guide bar when mounting it to the unit, in order to prevent partial wear.
WARNING
This saw is equipped with one of the following low kickback bar/chain combinations:
| RedMax Part Number | |
Bar Size | Guide Bar | Saw Chain |
|
|
|
14 (inch) | G0011 | 91SG52X |
(35cm) |
|
|
For replacement, use only above bar and chain, or the following;
OREGON BAR
14 inch S/N DOUBLE GUARD BAR, Mount code #A041.
OREGON CHAIN
91SG
AIR FILTER
A clogged air filter can reduce the engine performance. Daily check the filter elements and tap off attached saw dust. When cleaning, use warm, soapy water and dry completely before installing. When the element is broken or shrunk, replace with a new one. (MA7)
OILING PORT
Dismount the guide bar and check the oiling port for blocking by sawdust. (MA8)
GENERAL
Inspect the entire unit for fuel leakage, Ioose fastenings, and damage to major parts, especially handle joints and guide bar mounting. When