OP6 OP7 OP8, Checking OIL Supply, Stopping Engine

OP6

After starting the engine, run the chain at medium speed and see if chain oil is scattered off as shown in the figure. (OP6)

NOTE

The oil tank should become nearly empty by the time fuel in the tank is used up. Be sure to refill the oil tank every time when refueling the saw.

1.Release the throttle lever and let the engine run at low speed for a moment.

2.Put the ignition switch to the “O” position. (OP7)

NOTE

In case of emergency, turn off the switch without idling the engine.

The carburetor on your unit has been factory adjusted, but may require fine tuning due to change in operating conditions.

Before adjusting the carburetor, make sure that provided are clean air/fuel filters and fresh, properly mixed fuel.

When adjusting, take the following steps:

NOTE

Be sure to adjust the carburetor with the bar chain attached.

1.H and L needles are restricted within the number of turn as shown below.

L needle –1/4

2.Start engine and allow it to warm up in low speed for a few minutes.

3.Turn idle adjusting screw (T) counter-clockwise so that saw chain does not turn. If idling speed is too slow, turn the screw clockwise.