ENGINE
Maintenance, repair, or repracement of the emission control devices and systems, which are being done at thQ customers expense, may be performed by any non- road engine repair establishment or indi- vidual. Warranty repairs must be per- formed by an authorized engine manufac- turer'sservice outlet.
TO ADJUST THROTTLE CONTROL CABLE
•The throttle Control has been preset at the factory and adjustment should not be necessary. If adjustment is neces- sary, proceed as follows:
•With engine not running, move remote throttle control lever to =FAST" position.
•If throttle lever on engine touches high speed stop, no further adjustment js necessary. If throttle lever does not touch high speed stop, continue with adjustment procedure.
•Loosen cable clamp screw.
•Move throttle lever up until it touches
high speed stop, and hold in this posi- tion.
•Tighten cable clamp screw securely.
TO ADJUS T CARBURETOR
The carburetor has been preset at the fac- tory and'adjustment should not be neces- sary. However, engine performance can
be affected by differences in fuel, tempera- ture, altitude or load. If the carburetor
does need adjustment, contact your near- est authorized service center/department IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed set- ting can be dangerous. If you think the
Fuel Tank
/ Clamp
, Screw
Governor
Control
Lever
18