Worksaver SDM40-48, SDM40-72, SDM40-60 manual Preparation

Page 9

SAFETY INSTRUCTIONS (continued)

✯✯ ✯ ✯ PREPARATION

Never operate the tractor and cutter until you have read and completely understand this manual, the Tractor Operator’s Manual, and each of the Safety Messages found on the safety signs on the tractor and cutter.

Personal protection equipment including hard hat, safety glasses, safety shoes, and gloves are recommended during assembly, installation, operation, adjustment, maintaining, repairing, removal, or moving the implement. Do not allow long hair, loose fitting clothing or jewelry to be around moving parts.

PROLONGED EXPOSURE TO LOUD NOISE MAY CAUSE PERMANENT HEARING LOSS!

Tractors with or without Cutters attached can often be noisy enough to cause permanent, partial hearing loss. We recommend that you wear hearing protection on a full-time basis if the noise in the Operator’s position exceeds 80db. Noise over 85db on a long-term basis can cause severe hearing loss. Noise over 90db adjacent to the Operator over a long-term basis may cause permanent, total hearing loss. NOTE: Hearing loss from loud noise (from tractors, chain saws, radios, and other such sources close to the ear) is cumulative over a lifetime without hope of natural recovery.

Operate the cutter only with a tractor equipped with an approved Roll-Over Protective System (ROPS). Always wear your seat belt on tractors equipped with a ROPS. Serious injury or even death could result from falling off the tractor ---particularly during a turnover when the operator could be pinned under the ROPS or the tractor.

Clear area to be cut of stones, branches or other debris that might be thrown, causing injury or damage.

Operate only in daylight or good artificial light.

Ensure cutter is properly mounted, adjusted and in good operating condition.

Make sure driveline spring-activated locking pin or balls operate freely and are seated firmly in tractor PTO stub shaft groove.

✯ ✯ ✯ ✯

Ensure that all safety shielding and safety signs are properly installed and in good condition.

8

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Standard Duty 3-PT. Mounted Rotary Cutter To the Owner Table of ContentsSubject Model SDM40-48 Model SDM40-60 Model SDM40-72 Cutter SpecificationsE C K L I S T S Delivery Checklist Daily ChecklistP O Rtant Safety Information This Symbol Means Become Alert Your Safety is InvolvedBefore YOU Start DON’T TRY IT Equipment Safety GuidelinesTire Safety Safety SignsSafety Training Preparation Operational Safety Starting and Stopping SafetyOperational Safety Safety Instructions Transport Safety Maintenance Safety Storage Safety Maintenance SafetySafety Sign Locations Safety Sign LocationsRPM Speed Range only For Agricultural USE only Tractor Requirements and Prepa R AtionChecked Block Cutter in PositionPTO Driveline Insta L L Ation AT TA C H M E N TConnect the PTO Driveline AT this Time Gearbox OIL Fill General Safety Adjusting for WorkPRE Operation Checklist E R Ating Tips E R Ating TechniqueShredding Uneven TerrainA N S P O Rting A D E SRemoving Cutter from T R a C T O R OptionsB R I C Ation Information Routine MaintenanceDaily Checks AT the END of Your Cutting SeasonShear Bolt Replacement Blade ServicingBlade Sharpening Pair of Optional Chain Shielding Blade Beam & Gearbox Insta L L AtionBlade Beam & Gearbox R E M O VA L Proper Torque for FA S T E N E R S Leaves a streak of uncut or partially cut grass Troubleshooting GuideMaterial discharges from Cutter seems to require Excessive wear Disclaimer of Implied Warranties & Consequential Damages This Warranty Shall not ApplyWorksaver Description Reqd PTO Shaft Shear Bolt Protected PA RTS View & PA RTS ListPart Description Reqd SDM40-60 PA RTS View SDM40-48 4’ Cutter PA RTS ListSDM40-72 6’ Cutter PA RTS List SDM40-60 5’ Cutter PA RTS ListComer Gearbox LF-135.802 PA RTS View ’ Cutter Worksaver Comer Description Reqd Comer Gearbox LF PA RTS List ’ CutterComer Gearbox PA RTS View Comer Gearbox LF PA RTS List Make Every DAY Holiday from Accidents
Top Page Image Contents