Husqvarna HUV 4421-D / DXP ROLL-OVER Protective Structure and Safety Belts, Release Safety Belt

Page 17

Roll-Over Protective Structure and Safety Belts

ROLL-OVER PROTECTIVE STRUCTURE AND SAFETY BELTS

HUV 4421-G and HUV 4421-D vehicles are equipped with a Roll-Over Protective Structure (ROPS) and safety belts for each occupant. See following WARNING.

ýWARNING

•The ROPS must be properly installed before operating the vehicle. Husqvarna strongly urges that the vehicle’s occupants be properly restrained at all times with the safety belts provided.

Pregnant woman: Consult your doctor for specific recommendations. The safety belt should be worn securely and as low as possible over the hips and not on the waist.

Injured person: Depending on the injury, first check with your doctor for specific recommendations.

To secure the safety belt, sit up straight and well back in the seat. Pull the safety belt out of the retractor and insert the tab into the buckle. A click will be heard when the tab locks into the buckle. Position the lap belt as low as possible on the hips – not on the waist.

The retractor will lock the belt during a sudden stop. It also may lock if the occupant leans forward too quickly. A slow, easy motion will allow the belt to extend, and the occupant can move freely. If the safety belt cannot be pulled out of the retractor, firmly pull the belt and release it. It should then pull smoothly out of the retractor.

To release the safety belt, press the buckle release button (1) and allow the belt to retract (Figure 7). If the belt does not retract smoothly, pull it out and check for kinks or twists. Then make sure it remains free of twists as it retracts.

1

Figure 7 Release Safety Belt

ýWARNING

•Do not operate the vehicle with the ROPS removed. Doing so could result in property damage, personal injury, or death.

•Do not remove or modify any component of the ROPS structure. Doing so will result in voiding the ROPS certification and could weaken the ROPS, resulting in serious injury or death.

•Do not operate the vehicle if the ROPS is damaged. If the ROPS is damaged, replace the structure. Do not attempt repair.

•The driver and passenger must be restrained at all times with the safety belts provided to help prevent injury in the event of sudden braking, collision, or roll-over.

•In the event of a roll-over, do not attempt to jump or otherwise exit the vehicle. Remain seated with safety belt fastened and with arms and legs inside the vehicle.

WARNING CONTINUED ON NEXT PAGE...

2007 HUV 4421 Gasoline and Diesel Vehicle Owner’s Manual

Page 15

Page 16 Page 18
Image 17
Page 16 Page 18
Contents 2007 Utility Vehicles Page USA Foreword Table of Contents ALL HUV 4421 Models DRIVER/PASSENGER Warning Decal Rotating Parts Decal Diesel Vehicle Feature Identification Caut ION Safety DetailsDAN G E R Caut ION DAN G E R General WarningsAll-wheel Drive Warning General Information Controls and IndicatorsModel Identification See General Warnings onControls and Indicators KEY Switch Diesel Vehicles KEY Switch Gasoline VehiclesFORWARD/REVERSE Control Accelerator PedalVolt Accessory Outlet Steering Adjustment LockBrake Pedal Park BrakeLOW OIL Warning Light HIGH-TEMPERATURE Warning Light Diesel Vehicles onlyFuel GAUGE/HOUR Meter Headlight ControlRelease Safety Belt ROLL-OVER Protective Structure and Safety BeltsING Seat Latch and AdjustmentExhaust system Check for leaks PRE-OPERATION and Daily Safety ChecklistDriving Instructions Performance InspectionStarting the Vehicle ALL-WHEEL Drive AWD Operation Parking and Leaving the Vehicle BED Latch and Prop RODStopping the Vehicle Bed Latch Loading and Unloading CargoVehicle Load Capacities Transporting on a Trailer Towing with the VehicleSee General Warnings on DAN G E R StorageOFF Preparing the Vehicle for Extended StorageGasoline vehicles Returning the Stored Vehicle to ServiceMaintenance MaintenancePeriodic Service Schedule Periodic Service ScheduleMonthly service by owner Annual service by Periodic Lubrication Schedule Periodic Lubrication ScheduleLubrication Points Gasoline Vehicles Engine OIL Brake Fluid ReservoirBrake Fluid OIL Pressure Gasoline EngineDo not remove dipstick while engine is running Engine OIL Level CheckEngine Oil Draining Engine OIL and Filter ChangeDrain the engine oil. See Engine Oil Draining on Engine Oil Filter ChangeRemove Engine Oil Filter OIL Viscosity Engine Oil FillingFront differential Gearcase LubricationRear differential TransmissionEngine Coolant Diesel Vehicles AIR Filter ReplacementAIR Intake System Engine Coolant Level CheckAir Filter Removal Air Filter InstallationFueling Instructions Fuel Tank Gasoline Vehicles Biodiesel Fuel Diesel Vehicles OnlyDiesel Vehicles Only Draining Water from Fuel FilterFuel Filter BatteryBattery Jump Starting Using a Booster Battery Jump StartingAccessories Cleaning the VehicleElectric Winch Accessory See following NoteMUD Tire Option Subsequent Owner RegistrationSpecifications Vehicle SpecificationsDIMENSIONS/WEIGHT Tire Pressure Warranty Information Oxygenated Fuels Technical & Consumer Information Gasoline EnginesCarburetor Modification for High Altitude Operation Problems That May Affect Emissions U.S. and California Clean Air ActsReplacement Parts MaintenanceYour Warranty Rights and Obligations California Emission Control Warranty StatementPage Page Page Husqvarna Part Number 531 30 Edition Code 0706C0307B
Top Page Image Contents