Husqvarna HUV 4421-G / GXP, HUV 4421-D / DXP owner manual Maintenance

Page 30

Maintenance

5.Place the Forward/Reverse handle in the NEUTRAL position. Crank the engine until fuel is pumped into the carburetor (gasoline vehicles) and the fuel lines (all vehicles) and the engine starts. Turn the engine off. See following NOTE.

NOTE: Due to the oil added to the gasoline engine in preparation for storage, the engine may smoke excessively for a short time when it is run for the first time after storage.

6.Perform the Pre-Operation and Daily Safety Checklist on page 17 and the Performance Inspection on page 18.

MAINTENANCE

See General Warnings on page 8.

To ensure trouble-free vehicle performance, follow an established preventive maintenance program. Regular and consistent maintenance can prevent vehicle downtime and expensive repairs. Use the Pre-Operation and Daily Safety Checklist on page 17, the Performance Inspection on page 18, and the following Periodic Service Schedule and Periodic Lubrication Schedule to keep the vehicle in proper working condition.

Any vehicle not functioning correctly should not be used until it is properly repaired. This will prevent further damage to the vehicle and help prevent injury to occupants resulting from unsafe conditions.

Contact your local dealer/distributor for repairs and semiannual and annual periodic service.

ýWARNING

•Only trained technicians should service or repair the vehicle. Anyone doing even simple repairs or service should have knowledge and experience in electrical and mechanical repair. The appropriate instructions must be used when performing maintenance, service, or accessory installation.

•If any problems are found during scheduled inspection or service, do not operate vehicle until repairs are made. Failure to make necessary repairs could result in fire, property damage, severe personal injury, or death.

•Do not wear loose clothing or jewelry such as rings, watches, chains, etc., when servicing the vehicle.

•Turn key switch to the OFF position, remove the key, place the Forward/Reverse handle in the NEUTRAL position and chock the wheels prior to servicing.

•Moving parts: Do not attempt to service vehicle while engine is running.

•Hot! Do not attempt to service hot engine or exhaust system. Failure to heed this warning could result in severe burns.

•For vehicles with cargo beds, remove all cargo before raising the bed or servicing the vehicle. If the vehicle is equipped with a prop rod, ensure that it is securely engaged while bed is raised. Do not close bed until all persons are clear of cargo bed area. Keep hands clear of all crush areas. Do not drop cargo bed; lower gently and keep entire body clear. Failure to heed this warning could result in severe personal injury or death.

•Do not work on vehicle powertrain or under cargo bed when it is loaded.

•Gasoline vehicles only: Turn fuel shut-off valve to the closed (OFF) position (Figure 13, Page 28).

•To avoid unintentionally starting the vehicle:

-Disconnect battery cables, negative (–) cable first (Figure 1, Page 7).

WARNING CONTINUED ON NEXT PAGE...

Page 28 2007 HUV 4421 Gasoline and Diesel Vehicle Owner’s Manual

Page 29 Page 31
Image 30
Page 29 Page 31
Contents 2007 Utility Vehicles Page USA Foreword Table of Contents ALL HUV 4421 Models DRIVER/PASSENGER Warning Decal Rotating Parts Decal Diesel Vehicle Feature Identification Safety Details DAN G E R Caut IONCaut ION General Warnings DAN G E RAll-wheel Drive Warning Model Identification Controls and IndicatorsGeneral Information See General Warnings onControls and Indicators FORWARD/REVERSE Control KEY Switch Gasoline VehiclesKEY Switch Diesel Vehicles Accelerator PedalBrake Pedal Steering Adjustment LockVolt Accessory Outlet Park BrakeFuel GAUGE/HOUR Meter HIGH-TEMPERATURE Warning Light Diesel Vehicles onlyLOW OIL Warning Light Headlight ControlROLL-OVER Protective Structure and Safety Belts Release Safety BeltSeat Latch and Adjustment INGPRE-OPERATION and Daily Safety Checklist Exhaust system Check for leaksPerformance Inspection Driving InstructionsStarting the Vehicle ALL-WHEEL Drive AWD Operation BED Latch and Prop ROD Stopping the VehicleParking and Leaving the Vehicle Loading and Unloading Cargo Bed LatchVehicle Load Capacities Towing with the Vehicle Transporting on a TrailerStorage See General Warnings on DAN G E RPreparing the Vehicle for Extended Storage OFFReturning the Stored Vehicle to Service Gasoline vehiclesMaintenance MaintenancePeriodic Service Schedule Periodic Service ScheduleMonthly service by owner Annual service by Periodic Lubrication Schedule Periodic Lubrication ScheduleLubrication Points Gasoline Vehicles Brake Fluid Brake Fluid ReservoirEngine OIL OIL Pressure Gasoline EngineEngine OIL Level Check Do not remove dipstick while engine is runningEngine OIL and Filter Change Engine Oil DrainingEngine Oil Filter Change Drain the engine oil. See Engine Oil Draining onRemove Engine Oil Filter Engine Oil Filling OIL ViscosityGearcase Lubrication Front differentialTransmission Rear differentialAIR Intake System AIR Filter ReplacementEngine Coolant Diesel Vehicles Engine Coolant Level CheckAir Filter Installation Fueling InstructionsAir Filter Removal Biodiesel Fuel Diesel Vehicles Only Fuel Tank Gasoline VehiclesDraining Water from Fuel Filter Diesel Vehicles OnlyBattery Fuel FilterBattery Using a Booster Battery Jump Starting Jump StartingElectric Winch Accessory Cleaning the VehicleAccessories See following NoteSubsequent Owner Registration MUD Tire OptionVehicle Specifications SpecificationsDIMENSIONS/WEIGHT Tire Pressure Warranty Information Technical & Consumer Information Gasoline Engines Carburetor Modification for High Altitude OperationOxygenated Fuels Replacement Parts U.S. and California Clean Air ActsProblems That May Affect Emissions MaintenanceCalifornia Emission Control Warranty Statement Your Warranty Rights and ObligationsPage Page Page Husqvarna Part Number 531 30 Edition Code 0706C0307B
Top Page Image Contents