Husqvarna HUV 4421-D / DXP, HUV 4421-G / GXP Brake Pedal, Park Brake, Steering Adjustment Lock

Controls and Indicators

BRAKE PEDAL

The brake pedal (2) is located to the immediate left of the accelerator pedal (Figure 4 and Figure 5, Page 11). To slow or stop the vehicle, press the brake pedal.

PARK BRAKE

The park brake pedal (3) is located to the left of the brake pedal (Figure 4 and Figure 5, Page 11). To engage the park brake, first apply pressure to the brake pedal, then firmly press the park brake pedal until it latches into place. To disengage the park brake, pull the park brake release handle (4) (Figure 6). See following

WARNING.

ýWARNING

•The park brake has multiple locking positions and should be firmly locked to prevent the vehicle from rolling.

	4
	P
	P
000000	- 000000

Figure 6 Park Brake Release

STEERING ADJUSTMENT LOCK

The steering wheel position is adjustable. To adjust the steering wheel position, press down on the steering adjustment lock lever (5), then move the steering wheel to the desired position (Figure 4 and Figure 5, Page 11). While holding the steering wheel in the desired position, pull up on the steering adjustment lock lever to firmly lock the steering column in position. See following WARNING.

ýWARNING

•Ensure that the steering wheel lock is fully engaged before operating the vehicle.

12-VOLT ACCESSORY OUTLET

The 12-volt accessory outlet (11) is located to the right of the key switch (Figure 4 and Figure 5, Page 11). It provides a constant 12VDC with the key switch in the ON or OFF position. See following NOTE.

NOTE: Extended use of this accessory outlet can cause the battery to become heavily discharged.

2007 HUV 4421 Gasoline and Diesel Vehicle Owner’s Manual Page 13