Genie GTH-636 manual Welding Precautions, Hand Holds and Steps, Refueling

Page 18

GENERAL SAFETY

GENERAL SAFETY PROCEDURES

WELDING PRECAUTIONS

CAUTION

Any unauthorized welding can cause structural failure or possible personal injury. DO NOT weld on any structural member. All unauthorized welding will void the warranty.

HAND HOLDS AND STEPS

WARNING

Slips and falls can cause serious injury.

When getting on and off the machine, always maintain a three point contact with steps and hand rails while facing the machine.

DO NOT use the steering wheel or any other controls as handrails.

NEVER jump on or off the machine.

Be careful of slippery conditions on platforms, steps and handrails when getting on and off the machine.

ALWAYS shut off the engine before leaving the operator's station.

REFUELING

WARNING

Fires can cause death or severe personal injury.

Handle fuel with care. It is highly flammable. DO NOT refuel the machine while smoking or when near open flames or sparks.

ALWAYS stop the engine before refueling the machine. Fill the fuel tank outdoors.

Prevent fires by keeping the machine clean of trash, grease and

debris. ALWAYS clean up spilled fuel.

2 - 4

Image 18
Contents Operator’s Manual Table of Contents Section Rough Terrain Fork Lift Safety Table of Contents Rough Terrain Fork Lift Safety IntroductionStandards and Symbols StandardsSafety Training and KnowledgeOperators Responsibilities Managements Responsibilities Maintenance and Repair Operation Safety Rough Terrain Fork Lift Safety Rough Terrain Fork Lift Safety Rough Terrain Fork Lift Safety Section General Safety General Safety General Safety General Safety ProceduresWelding Precautions Hand Holds and StepsRefueling Hydraulic Safety Service Tires SafelyFluids Under Pressure Practice Safe Maintenance Boom SafetyUSE Seat Belt Avoid Electrical Power Lines Jump Starting Jump StartingProper Load Chart USE General Safety Section Controls and Instruments Controls and Instruments Controls and Instruments Operators CompartmentJoystick Control Functions Joystick Control Functions Button Pushed Service Brakes Parking BrakeFrame Sway Control Gauges Hydraulic Pump Destroke ButtonSteering TransmissionControls and Instruments Section Operation Operation Operation and Safety Guidelines OperationBefore Starting the Engine Starting the Engine Operation Before Operating the Forklift Operate the frame sway control a momentarily right and left Brake on Pump OFF Sway Control Headlight Heater Lics Operation Transporting a Load Operation Placing a Load Operation Section Maintenance Procedures Maintenance Procedures Maintenance Procedures General Safety PracticesBefore Servicing Fluid Under Pressure Daily Maintenance ScheduledmaintenanceCheck Hydraulic OIL Level Section Material Safety Data Material Safety Data Material Safety Data Material Safety Data Sheets MsdsCalifornia Proposition 65 Warnings California