Genie Boom Lift Operators Manual and Data Axle Guide for Safety

Page 39

OPERATION

STARTING THE ENGINE

DANGER

Any problems discovered in the steps prior to "BEFORE STARTING THE ENGINE" should be corrected before the machine is started.

DANGER

NEVER attempt to start the machine without being seated in the operator's compartment, the parking brake (B) in the on position and the transmission control (C) in the neutral position. Attempting to start the machine from outside the operator's compartment may result in property damage, serious injury or death.

C

DANGER

If the machine should start with the transmission control lever

(C)in gear, stop operation at once or property damage, serious injury or death may occur. Have a qualified service technician repair the machine.

Insert the ignition key in the ignition switch (D). Rotate the key

!∀#∀∃ &∋()∗∀#+

clockwise until the engine starts. Release the key when the

 

engine starts.

 

B

D

4 - 5

Image 39
Contents Operator’s Manual Table of Contents Section Rough Terrain Fork Lift Safety Table of Contents Introduction Rough Terrain Fork Lift SafetyStandards Standards and SymbolsTraining and Knowledge SafetyOperators Responsibilities Managements Responsibilities Maintenance and Repair Operation Safety Rough Terrain Fork Lift Safety Rough Terrain Fork Lift Safety Rough Terrain Fork Lift Safety Section General Safety General Safety General Safety Procedures General SafetyWelding Precautions Hand Holds and StepsRefueling Hydraulic Safety Service Tires SafelyFluids Under Pressure Practice Safe Maintenance Boom SafetyUSE Seat Belt Avoid Electrical Power Lines Jump Starting Jump StartingProper Load Chart USE General Safety Section Controls and Instruments Controls and Instruments Operators Compartment Controls and InstrumentsJoystick Control Functions Joystick Control Functions Button Pushed Parking Brake Service BrakesFrame Sway Control Hydraulic Pump Destroke Button GaugesTransmission SteeringControls and Instruments Section Operation Operation Operation Operation and Safety GuidelinesBefore Starting the Engine Starting the Engine Operation Before Operating the Forklift Operate the frame sway control a momentarily right and left Brake on Pump OFF Sway Control Headlight Heater Lics Operation Transporting a Load Operation Placing a Load Operation Section Maintenance Procedures Maintenance Procedures Maintenance Procedures General Safety PracticesBefore Servicing Fluid Under Pressure Scheduledmaintenance Daily MaintenanceCheck Hydraulic OIL Level Section Material Safety Data Material Safety Data Material Safety Data Sheets Msds Material Safety DataCalifornia California Proposition 65 Warnings