Genie Jump Starting Your Utility Vehicle: GTH-636 Battery and Safety Tips

Page 22

GENERAL SAFETY

JUMP STARTING

Location: The battery is located under the fuel tank / battery

box cover (A).

JUMP STARTING

Jump starting at the battery or battery replacement is required when the battery is discharged to the point where the battery will not crank the starter.

A

WARNING

Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm.

Batteries also contain other chemicals known to the State of

California to cause cancer.

Wash hands after handling.

WARNING

Never jump start the machine directly to the starter or the starter solenoid. Serious injury or death could result from the machine moving forward or backward.

WARNING

To avoid personal injury when jump starting with another machine, be certain that the machines are not touching. Never jump start a frozen battery as it will explode. Keep sparks and flames away from the battery. Lead acid batteries generate explosive gases when charging. Wear safety glasses when working near batteries.

The booster battery must be a 12 volt type. The machine used for jump starting must have a negative ground electrical system. To jump start the machine, proceed as follows:

1.Connect the positive (+) jumper cable to the positive

(+) post of the discharged battery.

2.Connect the other end of the same jumper cable to the positive (+) post of the booster battery.

3.Connect one end of the second jumper cable to the negative (-) post of the booster battery.

4.Make the final cable connection to the engine block or the furthest ground point away from the battery.

5.Start the engine.

6.Remove the jumper cables in the reverse order of their connection (i.e. negative cable ground connection first, etc.)

2 - 8

Image 22
Contents Operator’s Manual Table of Contents Section Rough Terrain Fork Lift Safety Table of Contents Rough Terrain Fork Lift Safety IntroductionStandards and Symbols StandardsSafety Training and KnowledgeOperators Responsibilities Managements Responsibilities Maintenance and Repair Operation Safety Rough Terrain Fork Lift Safety Rough Terrain Fork Lift Safety Rough Terrain Fork Lift Safety Section General Safety General Safety General Safety General Safety ProceduresHand Holds and Steps Welding PrecautionsRefueling Service Tires Safely Hydraulic SafetyFluids Under Pressure Boom Safety Practice Safe MaintenanceUSE Seat Belt Avoid Electrical Power Lines Jump Starting Jump StartingProper Load Chart USE General Safety Section Controls and Instruments Controls and Instruments Controls and Instruments Operators CompartmentJoystick Control Functions Joystick Control Functions Button Pushed Service Brakes Parking BrakeFrame Sway Control Gauges Hydraulic Pump Destroke ButtonSteering TransmissionControls and Instruments Section Operation Operation Operation and Safety Guidelines OperationBefore Starting the Engine Starting the Engine Operation Before Operating the Forklift Operate the frame sway control a momentarily right and left Brake on Pump OFF Sway Control Headlight Heater Lics Operation Transporting a Load Operation Placing a Load Operation Section Maintenance Procedures Maintenance Procedures General Safety Practices Maintenance ProceduresBefore Servicing Fluid Under Pressure Daily Maintenance ScheduledmaintenanceCheck Hydraulic OIL Level Section Material Safety Data Material Safety Data Material Safety Data Material Safety Data Sheets MsdsCalifornia Proposition 65 Warnings California