Genie GTH-636 manual Maintenance Procedures, General Safety Practices, Before Servicing

Page 51

MAINTENANCE PROCEDURES

GENERAL SAFETY PRACTICES

BEFORE SERVICING

Read the entire Maintenance Procedure Section.

Familiarize yourself with all the safety precautions listed in

Sections 1 & 2.

Pay close attention to all the safety alert symbols.

Be sure you understand the procedures detailed in this section.

Wear personal protective equipment.

Remove rings and jewelry.

Move the machine to a safe level work place.

Lower the boom and support all raised equipment.

Shut down the machine.

Remove the key from the ignition.

Be careful not to spill fuels and lubricants.

Do not fill or refuel the fuel tank while the engine is running or hot. Doing so could cause a fire and/or an explosion.

Do not smoke while refueling or working with fuel to avoid a fire and/or explosion.

IMPORTANT! Always clean up spilled fuel and/or lubricants to avoid polluting the earth.

5 - 3

Image 51
Contents Operator’s Manual Table of Contents Section Rough Terrain Fork Lift Safety Table of Contents Introduction Rough Terrain Fork Lift SafetyStandards Standards and SymbolsTraining and Knowledge SafetyOperators Responsibilities Managements Responsibilities Maintenance and Repair Operation Safety Rough Terrain Fork Lift Safety Rough Terrain Fork Lift Safety Rough Terrain Fork Lift Safety Section General Safety General Safety General Safety Procedures General SafetyWelding Precautions Hand Holds and StepsRefueling Hydraulic Safety Service Tires SafelyFluids Under Pressure Practice Safe Maintenance Boom SafetyUSE Seat Belt Avoid Electrical Power Lines Jump Starting Jump StartingProper Load Chart USE General Safety Section Controls and Instruments Controls and Instruments Operators Compartment Controls and InstrumentsJoystick Control Functions Joystick Control Functions Button Pushed Parking Brake Service BrakesFrame Sway Control Hydraulic Pump Destroke Button GaugesTransmission SteeringControls and Instruments Section Operation Operation Operation Operation and Safety GuidelinesBefore Starting the Engine Starting the Engine Operation Before Operating the Forklift Operate the frame sway control a momentarily right and left Brake on Pump OFF Sway Control Headlight Heater Lics Operation Transporting a Load Operation Placing a Load Operation Section Maintenance Procedures Maintenance Procedures Maintenance Procedures General Safety PracticesBefore Servicing Fluid Under Pressure Scheduledmaintenance Daily MaintenanceCheck Hydraulic OIL Level Section Material Safety Data Material Safety Data Material Safety Data Sheets Msds Material Safety DataCalifornia California Proposition 65 Warnings